Online Access Free 6103 Practice Test

Once created, which ACLI command line syntax is used to see that an instance of VRF is configured correctly?

• A.show ip vrf <name>
• B.show ip all vrf <name>
• C.show vrf <name> ip all
• D.show sys vrf <name>

To confirm that RSMLT will work on a set of VLANs, which network design aspect should be considered?

• A.RSMLT is enabled on all SMLT VLANs.
• B.RSMLT is enabled on the VLAN group.
• C.RSMLT is enabled on a SMLT VLAN.
• D.Router 1 always owns the network.

A customer is expressing concern about reliability for their single uplink connections to the wiring closet. The switches in the wiring closet support Distributed Multi-Link Trunking (DMLT).
What can be done so the Virtual Services Platform (VSP) 9000 can eliminate a single point of failure for the lowest cost?

• A.Add a second switch fabric module.
• B.Configure multiple VSP 9000 switches using Split Multi-Link Trunking (SMLT).
• C.Duplicate the trunk elements in software.
• D.Duplicate the trunks across separate modules using DMLT.

Policy-based traffic policers and traffic shapers identify traffic using a policy (a contract). Traffic that conforms to this policy (a service contract) is guaranteed transmission, and nonconforming traffic is considered in violation.
Which two statements about how Policy-based policers and shapers treat violations are true? (Choose two.)

• A.Traffic shaper allows the traffic to exceed the line rate, whereas traffic policers prevent traffic from exceeding the line rate.
• B.Policy based-shaping drop packets exceeding the peak rate.
• C.Traffic shapers buffer and shape traffic, whereas traffic policers discard or re-mark excess traffic.
• D.Policing occur on ingress.
• E.Both traffic policers and traffic shapers support the marking and re-marking of DSCP and 802.1p, using filter actions.

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF on the VSP 9000.
Which statement represents the proper order for configuring a new VRF?

• A.Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.
• B.Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.
• C.Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.
• D.Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.