Online Access Free 642-279 Practice Test

Which Cisco Telepresence infrastructure component allows for call control, OCS interoperability, and FindMe call routing?

• A.Cisco Telepresence Content Server
• B.Cisco Telepresence ISDN Gateway
• C.Cisco Telepresence Management Suite
• D.Video Communication Server

Which three items are core parts of the Cisco Telepresence T3 deployment? (Choose three.)

• A.Cisco WebEx
• B.Cisco TelePresence ISDN Gateway
• C.Cisco TelePresence Management Suite
• D.Content Server
• E.Cisco Telepresence T3 system
• F.Cisco Telepresence Server
• G.Video Communication Server

When configuring a Cisco Telepresence Server MSE 8710 blade from the web interface of the MSE 8000 supervisor blade, what is the first thing that you need to do?

• A.Configure the Ethernet Port A speed and duplex settings.
• B.Assign an IP address to the blade.
• C.Select the appropriate blade.
• D.Log in to the supervisor blade.

After you successfully change the IP address details of a Codec C90, you find that it is not possible to access the codec using SSH or HTTPS. However, it does respond to pings on the new address. What is the most likely reason for this?

• A.The configuration failed and there is another device with the same address that responds to the ping.
• B.The codec needs to reboot after the IP address change to bind all of the services to the new address.
• C.The codec has not been upgraded to a newer release of the software.
• D.The codec disabled the Telnet and HTTP services after the IP address change.

What would you normally check first if none of the three collaboration screens has an image?

• A.Check that the system power-on sequence was observed; the TCU should be powered-on first.
• B.Make sure that each collaboration screen has a USB cable connected to the TCU.
• C.Check the HDMI splitter in the right table leg for power, correct cabling, and proper operation.
• D.Check that the dip switches for each table button are set.