Online Access Free 642-732 Practice Test

A customer wants to deploy wireless services inside a 500-seat auditorium. Given the volume of potential users in this condensed area, what is the best option for AP deployment?

• A.place 802.11n APs along the outside edge with 2.4GHz directional antennas
• B.place 802.11n APs along the outside edge with dual-band directional antennas
• C.place 802.11n APs in the center with 2.4GHz sector antennas
• D.place 802.11n APs along the outside edge with 5GHz directional antennas
• E.place 802.11n APs in the center with dual-band sector antennas
• F.place 802.11n APs in the center with 5GHz sector antennas

Refer to the exhibit.

A company requires a multi-point bridge solution with Cisco 1400 series bridges. The central bridge (B1) is set to 10 dBm, the manufacturing remote bridge (B2) is set to 20 dBm, the inventory remote bridge (B3) is set to 20 dBm, and the shop remote bridge (B4) is set to 10 dBm. Which option is the maximum allowed power setting for all four bridges?

• A.B1=10dBmB2=24dBmB3=24dBmB4=24dBm
• B.B1=12dBmB2=12dBmB3=12dBmB4=12dBm
• C.B1=20dBmB2=20dBmB3=20dBmB4=20dBm
• D.B1=24dBmB2=24dBmB3=24dBmB4=24dBm
• E.B1=24dBmB2=12dBmB3=12dBmB4=12dBm
• F.B1=12dBmB2=24dBmB3=24dBmB4=24dBm

In evaluating a post-installation WLAN deployment, problems are occurring when a client roams from one AP to another. The client bounces back and forth between APs. Which three items can be checked to resolve this issue? (Choose three.)

• A.Check that the client roaming parameters are set properly.
• B.Check the RF levels of the first AP as the client moves toward the second AP.
• C.Check if the roaming settings in the AP are set properly for non-CCX clients.
• D.When a client roams from one AP to the next, check the client RSSI and SNR levels for both APs at the roaming point.
• E.Verify the authentication being used for the same test that the client would use under production.
• F.Simplify 802.1X/EAP by moving from external RADIUS to local authentication.

After installation of a new data-only wireless network, an engineer found that RRM has set all of the APs to a power level of 1. Which option describes the reason for this?

• A.TPC needs to be enabled.
• B.High co-channel interference exists.
• C.APs are too far apart for the set data rates.
• D.DTPC value is set too high.
• E.APs should be manually set initially.
• F.EDRRM is enabled.

For better compatibility with 802.11n clients, which 802.11a channels should be utilized?

• A.UNII-3 Band
• B.ISM Band
• C.UNII-2 Band - extended channels
• D.UNII-1 Band