Online Access Free 642-813 Practice Test

Which two statements describe a routed switch port on a multilayer switch? (Choose two.)

• A.The port is not associated with any VLAN.
• B.The routed switch port supports VLAN subinterfaces.
• C.The routed switch port ensures that STP remains in the forwarding state.
• D.The routed switch port is used when a switch has only one port per VLAN or subnet.
• E.Layer 2 switching and Layer 3 routing are mutually supported.

Which three statements apply to access control of both bridged and routed traffic for VLANs? (Choose three.)

• A.Only router ACLs can be applied to a VLAN interface.
• B.VLAN maps can be applied to a VLAN interface.
• C.VLAN maps and router ACLs can be used in combination.
• D.Bridged ACLs can be applied to the input and output directions of a VLAN interface.
• E.Router ACLs can be applied to the input and output directions of a VLAN interface.

DRAG DROP

Correct Answer:

You are tasked with designing a security solution for your network. What information should be gathered before you design the solution?

• A.detailed security device specifications
• B.results from pilot network testing
• C.a list of the customer requirements
• D.IP addressing design plans, so that the network can be appropriately segmented to mitigate potential network threats

Which two steps are necessary to configure inter-VLAN routing between multilayer switches? (Choose two.)

• A.Configure a dynamic routing protocol.
• B.Configure switch ports with the autostate exclude command.
• C.Configure access ports with network addresses.
• D.Configure SVI interfaces with IP addresses and subnet masks.
• E.Document the MAC addresses of the switch ports.