Online Access Free 642-832 Practice Test

The implementations group has been using the test bed to do a `proof-of-concept' that requires both Client
1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network
addressing, routing schemes, DHCP services, NTP services, layer 2 connectivity, FHRP services, and
device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241
address.
Use the supported commands to isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?

• A.DSW1
• B.R2
• C.R1
• D.R4
• E.R3
• F.DSW2
• G.ASW1

You have the followings commands on your Cisco Router:
ip ftp username admin
ip ftp password backup
You have been asked to switch from FTP to HTTP. Which two commands will you use to replace the existing commands?

• A.ip http client password backup
• B.ip http username admin
• C.ip http server username admin
• D.ip http server password backup
• E.ip http password backup
• F.ip http client username admin

What is the result of configuring the logging console warning command?

• A.Warning, error, critical, and informational messages will be logged on the console.
• B.Only warning messages will be logged on the console.
• C.The logging console warning command needs to be followed in the configuration with logging buffered byte size to specify the message buffer size for the console.
• D.Warning, critical, alert, and emergency messages will be logged on the console.
• E.Messages with a severity level of 4 and higher will be logged to all available TTY lines.

The implementations group has been using the test bed to do a `proof-of-concept'. After several changes to the network addressing, routing schemes, a trouble ticket has been opened indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on DSW2(2026::102:1).
Use the supported commands to isolated the cause of this fault and answer the following questions.
What is the solution to fault condition?

• A.Under ipv6 router ospf 6 configuration enter no passive-interface default command.
• B.Under ipv6 router ospf 6 configuration enter the network 2026::1:/122 area 0 command.
• C.Under the interface Serial0/0/0.12 configuration enter the ipv6 ospf 6 area 12 command.
• D.Under the interface Serial 0/0/0.23 configuration enter the ipv6 ospf 6 area 0 command.

Refer to the shown below. %PIX|ASA-3-105010: (Primary) Failover message block alloc failed * %PIX|ASA-3-106010: Deny inbound protocol src interface_name:dest_address/dest_port dst
interface_name:source_address/source_port * %PIX|ASA-3-106011: Deny inbound (No xlate) string * %PIX|ASA-3-106014: Deny inbound icmp src interface_name: IP_address dst interface_name:
IP_address (type dec, code dec) * %PIX-3-107003: RIP: Attempted reference of stale data encountered in function, line: line_num * %PIX|ASA-3-109010: Auth from inside_address/inside_port to outside_address/outside_port failed (too
many pending auths) on interface interface_name. * %PIX|ASA-3-109013: User must authenticate before using this service * %PIX|ASA-3-109016: Can't find authorization ACL acl_ID for user 'user' * %PIX|ASA-3-109018: Downloaded ACL acl_ID is empty * %PIX|ASA-3-109019: Downloaded ACL acl_ID has parsing error; ACE string * %PIX|ASA-3-109020: Downloaded ACL has config error; ACE * %PIX|ASA-3-109023: User from source_address/source_port to dest_address/dest_port on interface
outside_interface must authenticate before using this service. What statement is correct regarding the output shown in the graphic?

• A.The first log message is an error message with a severity level of 3.
• B.These messages regarding interface status are normal output and will always be displayed when you exit config mode.
• C.The second message would be shown if the logging console warning command had been issued.
• D.These two log messages will not have a severity level. They are not errors but are just informational messages.
• E.The first log message is categorized as a warning message.