Online Access Free 642-980 Practice Test

Which two occurrences happen during an ISSU? (Choose two.)

• A.LACP is not affected because ISSU should not impact peers that rely on LACP because the recovery time is less than 90 seconds.
• B.FLOGI/fdisc or logo requests from servers fail until the ISSU is complete.
• C.The time-to-live value for CDP is increased (360 seconds) if it is less than the recommended timeout value.
• D.The control plane is offline for up to 300 seconds.
• E.NTP sessions stay alive and active.

Which statement is true regarding the port channel 100 and 101 configurations between the Nexus 7010 switches?

• A.The vPC assignments on N7010-C2 are incorrectly swapped
• B.LACP is not configured to initiate negotiations.
• C.The vPC peer-keepalive is down between the two Nexus 7000 switches.
• D.N7010-C1 is not allowing any active VLAN traffic to pass on Po100 and Po101.

Refer to the Exhibit.

Which two statements are determined from the output of show interface? (Choose two.)

• A.The CRC feature is not enabled on this device.
• B.This device may have a hardware problem.
• C.Jumbo frames are not configured on this device.
• D.The peer device may have a hardware problem.
• E.Jumbo frames are configured on the peer device.
• F.The link between these devices may have a hardware problem.

A customer is deploying multihop FCoE in its network. Which guideline must the customer follow with respect to VE ports to make this deployment possible?

• A.Auto mode on the vFC interface is supported.
• B.A VE port is disabled for trunk mode by default.
• C.VE-port trunking is supported over FCoE-enabled VLANs.
• D.VE-port interface binding to MAC addresses is supported.

Refer to the exhibit.

Customer is having problems with a device in VLAN100? What would fix the problem?

• A.Change interface fc1fc1/1 into a trunk port and remove VSAN 100.
• B.Change interface fc2/4 into VSAN 100.
• C.Change interface fc2/4 into a trunk port.
• D.Change interface fc1fc1/2 into VSAN 100.
• E.Move the trunk port into VSAN 100.