Online Access Free ACMP_6.1 Practice Test

ip access-list session anewone user network 10.1.1.0 255.255.255.0 any permit user any any permit host 10.1.1.1 host 10.2.2.2 any deny A user sends a frame with the following attributes:
Source IP: 10.1.1.1 Destination IP: 10.2.2.2 Destination Port: 25
Based on the above Mobility Controller configuration file segment, what will this policy do with the user frame?

• A.The frame is discarded because of the implicit deny all at the end of the policy.
• B.The frame is accepted because of the statement: user network 10.1.1.0 255.255.255.0 any permit.
• C.The frame is discarded because of the statement: user host 10.1.1.1 host 10.2.2.2 deny.
• D.The frame is accepted because of the statement: user any any permit.
• E.This is not a valid policy.

A customer has configured a 3000 controller with the following commands:
Vlan 55
Vlan 56
Vlan 57
Interface gigabitethernet 1/0 switchport mode trunk
switchport trunk native vlan 55
switchport trunk allowed vlan 55-57
Which of the following sentences best describes this port?

• A.All traffic in vlan 55 will be dropped and all traffic in vlan 56 and 57 will be trunked with and 802.1Q tag
• B.All traffic in vlan 55 will be sent with an 802.1Q tag while vlan 56 and 57 traffic will be trunked untagged
• C.All traffic in vlan 55, 56 and 57 will be trunked with an 802.1Q tag
• D.All traffic in vlan 56 and 57 will be sent with an 802.1Q tag while vlan 55 traffic will be trunked untagged

By default, how long will an AP scan a single channel when ARM is enabled?

• A.100 milliseconds
• B.90 milliseconds
• C.80 milliseconds
• D.110 milliseconds

How does the ARM's Band Steering feature encourage 5GHz capable clients to move/connect to the 5GHz radios of Aruba APs?

• A.ARM "hides" the 2.4GHz radios from 5GHz capable clients
• B.It's not possible the move clients to 5GHz radios when they can see both 2.4 and 5GHz APs
• C.Current Wi-Fi chipset firmware supports this by default
• D.ARM utilizes third party software on the wireless clients

A user logged in with the Captive Portal settings shown in the above screen capture.

What does the user need to do to logout?

• A.click Logout on the browser screen
• B.wait 60 minutes then logout
• C.wait 30 minutes then logout
• D.he cannot logout