Online Access Free C-IBP-2205 Practice Test

What are some of the prerequisites for configuring a planning area that results in a successful consistency check?Note: There are 2 correct answers to this question.

• A.Assign the compound master data type and its component master data types.
• B.Configure at most two input key figures on the same planning level in a key figure calculation.
• C.Configure at least one calculated key figure for the planning area.
• D.Specify a planning horizon in the planning area for each level of the assigned time profile.

Which parts of the S&OP high-level process would the Inventory planning and optimization process fit into?Note: There are 2 correct answers to this question.

• A.Reconciliation Review, by providing inventory parameters for one consolidated plan
• B.Supply Review, by providing an input to supply network planning
• C.Management business Review, by providing the inventory targets for endorsement
• D.Demand Review, by using the output of demand planning as input into calculations

You are evaluating criteria for choosing the solver to support planning for a complex supply chain. What are some of the points that should be reviewed?Note: There are 2 correct answers to this question.

• A.Planning results can be generated faster by the optimizer.
• B.Finite heuristics can achieve demand prioritization and pegging.
• C.Push and Pull production models are used by the optimizer.
• D.Prioritization of demand elements one by one is achieved by unconstrained heuristics.

You are invited to review a problem with a customer's SAP IBP Excel template performance.What areas with the biggest potential performance impact would you focus on?Note: There are 2 correct answers to this question.

• A.Number of analytics charts displaying key figures' values
• B.Excessive SAP IBP formatting in the Microsoft Excel UI
• C.Complex calculation graphs for key figures
• D.Number of local members and complexity of calculations

You are modeling a new product introduction.Which of the following steps can be part of your modeling process in the Manage Product Lifecycle app?Note: There are 2 correct answers to this question.

• A.Enter the product family to which the new product belongs
• B.Create planning objects for new combinations in the app
• C.Copy the launch dimension from the reference product to the new product
• D.Enter the Phase-out Start Date and Phase-out End Date