Online Access Free C-TS411-2021 Practice Test

Which application areas can be set inside a release key of an engineering change number?Note: There are 2 correct Answers to this question.

• A.Costing
• B.Planning and production
• C.Sales and distribution
• D.Plant maintenance

You want to use a procedure to set a value in a single-level configuration using a variant table T1.Variant table T1 has only two characteristics C1 and C2. C1 is a key field.The following syntax is incorrect: table T1 (C1 = C1, C2 = C2)Where do you have to insert $self?

• A.table T1 ($self.C1 = C1, C2 = C2)
• B.table T1 (C1 = C1, $self.C2 = C2)
• C.table T1 (C1 = C1, C2 = $self.C2)
• D.table T1 (C1 = $self.C1, C2 = C2)

Where can you specify a processing sequence during an assignment?

• A.Constraint Nets
• B.Procedures
• C.Constraints
• D.Pre- and Selection Conditions

Some of your classifications are locked or incomplete. How do you find them?Note: There are 2 correct Answers to this question.

• A.Use the Classification status.
• B.Use the Class list.
• C.Use Find in Classes and filter the search result.
• D.Use the Characteristics list.

What controls the material BOM item category?Note: There are 2 correct Answers to this question.

• A.A work center is required.
• B.A material number is required.
• C.A negative quantity is allowed.
• D.A change number is required.