Miro's vehicle and Stephanie's vehicle collide with each other in New Brunswick. Neither of them has loss or damage coverage, also known as collision coverage. The chart shows the physical damage and assigned fault. How would the payment be apportioned? Driver | Physical Damage | Fault Percent Miro | $4,000 | 50% Stephanie | $2,000 | 50%
Correct Answer: A
In a direct compensation property damage arrangement, each insured claims from their own insurer for the portion of vehicle damage for which they are not at fault. The absence of collision coverage does not prevent recovery of the not-at-fault portion where direct compensation applies. Miro's total physical damage is $4,000 and he is 50 percent at fault. Therefore, he can recover the 50 percent not-at-fault portion: $4,000 × 50 percent = $2,000. Stephanie's total physical damage is $2,000 and she is also 50 percent at fault. She can recover $2,000 × 50 percent = $1,000 from her own insurer. Option B and option C incorrectly involve recovery from both insurers, which is not how direct compensation is structured. Option D wrongly assumes full recovery despite the assigned fault and then subrogation between insurers. The correct settlement follows the fault percentage and each insured's own insurer pays the recoverable not-at-fault portion. References/topics: Automobile Insurance; direct compensation property damage, fault apportionment, collision coverage, automobile physical damage claims.
Question 2
A commercial general liability policy has an aggregate limit of $1,000,000. During the current term, the insurer has already paid for three liability claims: one for $100,000, a second for $500,000, and a third for $300,000. How much will the insurer pay if a new claim of $300,000 is submitted?
Correct Answer: B
An aggregate limit is the maximum amount the insurer will pay for all covered claims subject to that aggregate during the policy period. The policy aggregate is $1,000,000. The insurer has already paid $100,000 + $500,000 + $300,000, for a total of $900,000. That leaves only $100,000 available under the aggregate. Therefore, even though the new claim is $300,000, the insurer can pay only the remaining $100,000. Option C would be correct only if the full aggregate remained available or if the claim were subject to a separate unaffected limit. Option A is wrong because some aggregate remains. Option D is the original aggregate, not the remaining available amount. Brokers must explain aggregate limits to commercial clients because a policy may appear to have a large limit, but prior claims can erode available coverage. This is especially important for businesses with frequent premises, products, or operations liability losses. References/topics: Liability Insurance; CGL aggregate limits, limit erosion, claim payments, remaining available insurance.
Question 3
Michelle is a new agent who would like to protect herself against possible errors and omissions claims. What should Michelle practice in her interactions with clients and insurers?
Correct Answer: D
A disciplined intermediary protects against E & O exposure by recognizing the limits of their professional competence. Michelle should recommend that clients consult outside experts when the issue falls outside insurance expertise, such as legal ownership, tax treatment, engineering concerns, environmental hazards, financial planning, or construction valuation beyond ordinary insurance tools. This is the safest and most professional response because it prevents the agent from giving unauthorized or unreliable advice. Option A is poor practice because exclusive use of close-ended questions can prevent discovery of important facts; brokers and agents should use a mix of open-ended and targeted questions. Option B is unrealistic and unnecessary because written, telephone, electronic, and face-to-face communication can all be valid if properly documented. Option C is dangerous because giving advice outside one's expertise creates a direct E & O hazard. Proper file documentation, referrals to qualified experts, confirmation of client instructions, and accurate communication with insurers are all central to E & O prevention. References/topics: Communication and Service Skills; E & O prevention, professional boundaries, documentation, client communication.
Question 4
What information is typically included in a cover letter prepared by a broker for the insured?
Correct Answer: C
A broker's cover letter commonly reminds the insured to review the policy documents for accuracy and to report any errors, omissions, or required changes immediately. This is not a ceremonial document; it is an important service and E & O control. The policy should be checked for correct named insured, mailing address, risk location, mortgagee or loss payee, coverage limits, deductibles, endorsements, exclusions, vehicle details, drivers, occupancy, and business operations. Option A is not normally the purpose of a client cover letter; the insurer's internal underwriting process is not usually explained in detail. Option B may be relevant in disclosure or relationship transparency contexts, but it is not the standard content being tested. Option D may apply where commission disclosure is required by regulation or brokerage practice, but it is not the typical core purpose of the cover letter. The strongest answer is C because the cover letter prompts the client to verify the policy and creates evidence that the broker encouraged review. References/topics: Communication and Service Skills; cover letters, policy delivery, client review, documentation, E & O risk management.
Question 5
W & A Insurers Inc. has a capacity of $30 million for any single property risk. It also has a reinsurance agreement with Tri-insurance Inc. for an additional $40 million. A broker approaches W & A Insurers Inc. with a request to write a low-hazard $37 million liability risk. What is the insurer's retention if it accepts and reinsures the risk?
Correct Answer: B
Retention is the portion of the risk the insurer keeps for its own account before reinsurance responds. In this scenario, W & A's own capacity is $30 million. The additional reinsurance agreement provides extra capacity above that amount, allowing W & A to accept a larger risk than it would otherwise retain alone. If W & A accepts a $37 million risk and reinsures the excess portion, it would retain $30 million and cede the remaining $7 million to the reinsurer. Option C is incorrect because $37 million is the total risk presented, not the insurer's retained amount after reinsurance. Option D represents the available reinsurance agreement, not W & A's retention. Option A has no technical basis in the facts provided. This question tests the difference between gross line, net retention, capacity, and reinsured portion. Brokers must understand this because larger risks may require layering, subscription, facultative reinsurance, or market-sharing arrangements before coverage can be confirmed. References/topics: From Quote to Policy; insurer capacity, retention, reinsurance, risk placement, underwriting authority.