What is the general use of an R chart?
Response:

The hazard function is:
I. The probability of failure during a very small time interval, assuming a failure occurs before that time.
II. A function of constant failure rate only.
III. A function of increasing failure rate only.
IV. The ratio of the probability density function to the reliability function.
Response:

The success of the FMEA is principally dependent on:
I. Good communication between the reliability engineer and the designer.
II. Use of the correct form and definitions.
III. Early determination of the reliability critical items.
Response:

A failure reporting and corrective action system should ensure that all steps are taken to:
Response:

Human factors in product safety planning are assessed for which of the following reasons?
I. To allocate the proper balance between man and machine.
II. To address the limitations of human beings.
III. To determine the user hardware interaction.
Response: