Online Access Free CTFL-UK Practice Test

Which of the following is not a major task of Exit criteria?

• A.Writing a test summary report for stakeholders.
• B.Logging the outcome of test execution.
• C.Checking test logs against the exit criteria specified in test planning.
• D.Assessing if more tests are needed.

A booking system for a city bus service prices its fares according to the time of travel:
* Peak-time tariff starts at 0600 and finishes at 1000 am
* Off-peak tariff applies during all other times of service
* The bus service does not operate between 2300 and the start of the next day's peak service
Note that all times mentioned are inclusive.
When applying the equivalence partitioning test design technique, which of the following options, shows test case inputs that each fall into a different equivalence partition?

• A.0600, 1000, 1200
• B.0100, 0800, 2200
• C.1001, 1300, 2259
• D.2400, 1000, 2301

Which of the following statements BEST describes one of the seven key principles of software testing?

• A.Exhaustive testing is, with sufficient effort and tool support, feasible for all software.
• B.It is normally impossible to test all input / output combinations for a software system.
• C.The purpose of testing is to demonstrate the absence of defects. The purpose of testing is to demonstrate the absence of defects.
• D.Automated tests are better than manual tests for avoiding the Exhaustive Testing.

The development manager is managing the review of the responses received from bidders, and has asked the in-house test manager to provide a review checklist for the test management aspects of the responses. Which of the following checkpoints would be appropriate? 2 credits

• A.The bidder's project strategy shows that the data content of all the test environments conforms to EU standards.
• B.The bidder's test policy should enforce that incident management fully conforms to IEEE
  1044.
• C.The bidder's project test plan depicts a phased implementation with later delivery dates to be confirmed and states that test deliverables will be developed using IEEE 829 as a guide.
• D.The bidder's test plan shows that the application will be delivered for acceptance in six months time.

A deviation from the specified or expected behavior that is visible to end-users is called:

• A.a defect
• B.a failure
• C.an error
• D.a fault