Free Access CWNP.CWDP-304.v2025-03-08.q105 Practice Test (Page 12)

Question 51

Given: You are evaluating the theoretical and real-world RF gain benefits of transmit and receive features introduced by 802.11 with MIMO. This exercise allows you to quantify the feature's value in a real-world environment.
What is the maximum theoretical signal gain of chip-based TxBF and MRC (as features) when compared to the same AP using only a single antenna for transmit and receive (effectively simulating a 1x1 chip)?
Response:

A.2 Rx or Tx chains = approx 4-6.5 dBi gain3 Rx or Tx chains = approx 7-10 dBi gain4 Rx or Tx chains = approx 10-12 dBi gain

B.2 Rx or Tx chains = 3 dBi gain3 Rx or Tx chains = approx 5 dBi gain4 Rx or Tx chains = 6 dBi gain

C.2 Rx or Tx chains = 3 dBi gain3 Rx or Tx chains = 6 dBi gain4 Rx or Tx chains = 9 dBi gain

D.2 Rx or Tx chains = 1 dBi gain3 Rx or Tx chains = 2 dBi gain4 Rx or Tx chains = 3 dBi gain

Question 52

An MSA commonly addresses at least which two legal categories?

A.Indemnity clause

B.Nondisclosure agreement

C.Hold harmless

D.Intellectual property protection

Question 53

Given: A WLAN controller is connected to ABC Company's core layer 3 Ethernet switch with an IEEE 802.1 Q trunk connection. The WLAN controller's native VLAN is VLAN 6 and its IP address is 10.0.14.2 /24. Lightweight APs supporting centralized forwarding are connected to the network on VLANs 7,
8, and 9, and they each build a Layer 3 tunnel back to the WLAN controller's IP address.
The dynamically assigned IP addresses received by each AP from a DHCP server will be ________________.

A.Associated with the VLAN on which they are connected.

B.Associated with a non-routable VLAN until the MAC address of the AP is removed from the controller's MAC filter

C.Associated with VLAN 1, the default VLAN for new APs

D.Associated with the native VLAN of the WLAN controller.

Question 54

NicoCo is building a new facility and would like to install a WLAN for primary connectivity of all clients.
The requirements are dual-spectrum 802.11n supporting voice and location tracking.
What type of pre-deployment survey should be performed?
Response:

A.Passive, all channels

B.Active, using a lowest common denominator client

C.Active, using a voice handset

D.Predictive

E.Passive, using optimized channels

Question 55

After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?

A.Perform an AP-on-a-Stick survey using AP locations based upon the predictive design to confirm each AP's placement.

B.Deploy all of the APs as they're shown in the predictive design and perform a passive site survey.

C.Deploy all of the APs as they're shown in the predictive design and perform an active site survey.

D.Use a client device positioned where the APs will be installed and measure the signal from the client device.

Latest Upload: 201PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 296Nokia.4A0-113.v2026-05-01.q69; 253EC-COUNCIL.312-49v11.v2026-04-30.q214; 228Microsoft.MB-820.v2026-04-30.q101; 209Salesforce.MC-202.v2026-04-30.q57; 205BICSI.INSTC_V8.v2026-04-29.q53; 333NMLS.MLO.v2026-04-28.q82; 242NCARB.Project-Management.v2026-04-28.q27; 459EMC.D-AV-DY-23.v2026-04-27.q184; 1113ServiceNow.CSA.v2026-04-27.q483

Question 51

Question 52

Question 53

Question 54

Question 55

Download PDF File