Free Access CWNP.CWDP-305.v2026-03-09.q251 Practice Test (Page 20)

Question 91

When deploying a new WLAN infrastructure using Power over Ethernet (PoE) to power the access points (APs), you find that a known good AP is not powering up. You connect your laptop using the same cable without any issues. What is the most likely reason the AP did not power up?

A.Missing AP licenses on the controller

B.Spanning-tree convergence

C.Layer 3 routing

D.Lack of PoE budget on the switch

Question 92

Looking at a client radio specification sheet that states Receive Sensitivity of #82 dBm @ 18 Mbps would mean:

A.It would need to hear a signal <#82 dBm in order to use the 24 Mbps PHY rate.

B.It is only capable of transmitting at 18 Mbps PHY rates at #82 dBm.

C.It must hear a signal >#82 dBm in order to demodulate the 18 Mbps PHY rate.

D.It must hear a signal <#82 dBm in order to demodulate the 18 Mbps PHY rate.

Question 93

After designing and deploying a WLAN infrastructure, you realized the CCI is causing poor performance in the 2.4 GHz band. Primarily, you've designed the WLAN for 5 GHz and 2.4 GHz as a best effort. You found out that the implementers didn't follow your guidelines when configuring the WLAN infrastructure. What can you do to minimize as much as possible the CCI impact in the 2.4 GHz band?

A.Increase the transmit power on all APs

B.Add more APs to the infrastructure

C.Use all channels available in the 2.4 GHz band

D.Turn-off 2.4 GHz radios on some APs

Question 94

If you choose to recommend dynamic channel assignment for the APs in your WLAN design what action should you also recommend'?

A.Ensure that the output power of an APs is set to the minimum available in the system interface

B.Ensure that the output power of all APs is set to the maximum allowed in the regulatory domain

C.Replace all antennas with panel antennas instead of omnidirectional antennas

D.Configure the settings used by the dynamic channel assignment algorithm optimally for your design

Question 95

What is the minimum PoE budget needed on a switch to support 6 (six) APs that can only be powered using IEEE 802.3at if no other details are provided?

A.320 W

B.180 W

C.60 W

D.240 W

Other Version: 3165CWNP.CWDP-305.v2025-08-21.q200

Latest Upload: 253PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 362Nokia.4A0-113.v2026-05-01.q69; 398EC-COUNCIL.312-49v11.v2026-04-30.q214; 312Microsoft.MB-820.v2026-04-30.q101; 248Salesforce.MC-202.v2026-04-30.q57; 277BICSI.INSTC_V8.v2026-04-29.q53; 412NMLS.MLO.v2026-04-28.q82; 280NCARB.Project-Management.v2026-04-28.q27; 495EMC.D-AV-DY-23.v2026-04-27.q184; 1304ServiceNow.CSA.v2026-04-27.q483

Question 91

Question 92

Question 93

Question 94

Question 95

Download PDF File