The first step in any pest control program, especially under IPM, is an inspection to identify the pest, assess the infestation's extent, and determine contributing factors. TheGeneral Pest Management:
Guide for Commercial Applicators - Category 7A(Chapter 4: IPM) emphasizes that inspection guides the development of a targeted control strategy. Option A (pesticide application) should only occur after inspection and other methods are considered. Option C (alteration of the habitat) is a control method that follows inspection.

Pesticide resistance occurs when pests develop tolerance to a pesticide due to overuse. IPM strategies, as outlined in theGeneral Pest Management: Guide for Commercial Applicators - Category 7A (Chapter 4: IPM), recommend using multiple components (e.g., rotating pesticide classes, incorporating non-chemical methods like sanitation or traps) to control pests and reduce resistance risk. Option A (routine spraying) increases resistance by overexposing pests to the same chemical. Option C (increased dosage) can exacerbate resistance and is not an IPM practice.

TEMPRID SC contains two active ingredients: imidacloprid and beta-cyfluthrin. Imidacloprid acts as a systemic insecticide, being absorbed by the pest and affecting its nervous system over time, while beta- cyfluthrin acts as a contact insecticide, killing pests on direct exposure by disrupting nerve function.
The TEMPRID SC label and theGeneral Pest Management: Guide for Commercial Applicators - Category 7A(Chapter 6: Pesticide Types) describe these dual modes of action, which make TEMPRID effective against a wide range of pests. Option B (combined neurotoxin only) is partially correct but does not specify the contact and systemic nature. Option C (mist or foam) refers to application methods, not modes of action.

The TEMPRID SC label defines perimeter spraying for outdoor applications as treating two to three feet up the walls of a structure and a band up to 10 feet wide along the ground surrounding the structure. This ensures coverage of areas where pests like earwigs or ticks may enter or harbor. The General Pest Management: Guide for Commercial Applicators - Category 7A(Chapter 5: Pesticide Application) aligns with this standard for perimeter treatments. Option A (one foot up and one foot along) is too limited and not per the label. Option C (prohibiting wall spraying) is incorrect, as the label explicitly allows wall spraying up to 2-3 feet.

The TEMPRID SC label explicitly states that applicators should not spray bed linens or other materials that come in direct contact with people, such as mattresses, pillows, or clothing, to prevent human exposure to the pesticide. This is a critical safety instruction for indoor use in Category 7A applications.
Option A (broadcast treatment to floors) is incorrect, as TEMPRID is typically applied as a spot or crack-and-crevice treatment indoors, not a broadcast application, unless specified. Option C (high- pressure system) is incorrect, as high-pressure systems can disperse pests like bedbugs and are not recommended for indoor use; low-pressure, targeted applications are preferred.