Online Access Free D-PSC-MN-01 Practice Test

A customer is planning to add a node to a Dell PowerScale cluster running OneFS 9.0.
Which command can they use from the CLI?

• A.isi node add --node-lnn
• B.isi devices node add --node-lnn
• C.isi devices -add
• D.isi devices node add --serial-number=<SN>

What does a terracotta colored handle indicate on Dell PowerScale Gen6 hardware?

• A.The FRU must be replaced.
• B.The node must be shut down for maintenance procedures.
• C.The component must not be removed while hardware is online.
• D.The node can remain online when replacing a hardware component.

A platform engineer must replace a failed chassis on a Dell PowerScale Gen6 cluster. What must the engineer do after powering off the nodes?

• A.Remove the drives, install the chassis, and place the drives in the new chassis.
• B.Remove the drives and compute modules and reimage each drive before installing them in the chassis.
• C.Remove the drive sleds and motherboard and transfer them to the new chassis.
• D.Remove the drive sleds, label them for identification, and place the drive sleds In the newly installed chassis.

What is the maximum recommended ambient temperature for the operation of a Dell EMC PowerScale Gen 6 node?

• A.27 degrees C (80 degrees F)
• B.35 degrees C (95 degrees F)
• C.40 degrees C (104 degrees F)
• D.32 degrees C (89 degrees F)

A PowerScale customer is planning to expand a Dell EMC PowerScale Gen 5 cluster with H500 nodes.
What is a consideration?

• A.Minimum of three Gen 6 nodes are needed.
• B.Minimum of four H500 nodes are needed.
• C.Only Gen 5 nodes can be added to the cluster.
• D.Backend is not supported.