Online Access Free D-PVM-OE-01 Practice Test

If a data reduction hardware I/O module fails, what happens to incoming data?

• A.Incoming data is held in cache until the failed hardware I/O module is replaced
• B.Software-based reduction is used to reduce data
• C.Data is written to disk without any data reduction
• D.Hardware I/O module in the partner director within the engine is used to reduce data

Which service has to be manually started first when Unisphere services are down?

• A.SMAS
• B.SYMEVENT
• C.SMASDB
• D.SMI-S

Four snapshots of a single source volume have been created. The snapshots were created with the same name at 8:00 AM, 10:00 AM, 12:00 PM: and 2:00 PM.
What is the generation number of the snapshot created at 2:00 PM?

• A.0
• B.3
• C.4
• D.1

What is a recommendation when using Open Replicator to migrate data from a supported third-party array to a VMAX3 array?

• A.Control devices on the VMAX3 array must be set to Not Ready for the duration of the migration
• B.Host I/O to the remote devices on the third-party array can continue during the migration
• C.Host I/O to the remote devices on the third-party array should be stopped for the duration of the migration
• D.Host I/O to the control devices on the VMAX3 array is allowed after the migration completes

What can be managed from the Configure Storage section using the Dell VSI vSphere plug-in?

• A.Port flags
• B.Access control
• C.Remote replication
• D.Snapshots