Online Access Free D-SNC-DY-00 Practice Test

Configure the system to meet these requirements.
. Configure R1 with AS 1.
. R1 must use a static neighbor assignment for BGP peering.
. R1 needs to redistribute all current and future connected IPv4 routes.
All the required BGP configurations have already been completed on R2.
R2 resides in BGP AS 2.

In what order should these commands be entered to configure an access port in SONiC CLI if the required VLAN is already configured?

Correct Answer:

Explanation:
To configure an access port on the SONiC CLI, the commands should be entered in the following order:
* Enter global configuration mode with configure terminal.
* Specify the interface to configure using interface ethernet 1/1.
* Set the interface to access mode and assign it to VLAN 20 with switchport access vlan 20.
* Exit the interface configuration mode with exit.
References:
* Dell Technologies SONiC Command Reference Guide
* Dell Networking Configuration Guide

How many times must BGP be configured when running symmetric IRB with two VFRs?

• A.5
• B.2
• C.3
• D.4

Refer to the exhibit.

What type of route is shown?

• A.Type 3 host route from external VTEP
• B.Type 5 host route from another VTEP
• C.Type 2 host route from another VTEP
• D.Type 3 host route from another VTEP

What does the show vian command display?

• A.Only VLANs in an active state
• B.All 4094 VLANs
• C.All configured VLANs