Online Access Free DCAN-100 Practice Test

Refer to the output:

A network outage occurs. A technician tries to log in to a switch by Telnet using the correct local username and password.
What is causing the login failure?

• A.Local accounts are not allowed.
• B.A Telnet approved account must be used.
• C.TACACS credentials are not being used.
• D.Authentication is not enabled on Telnet.

A technician decides to create an ACL. The technician includes all host and/or protocols allowed within the ACL.
Why must the technician take this step?

• A.The ACL needs well-formed structuring.
• B.The ACL will malfunction without a certain number of statements.
• C.The AL includes an implicit deny at the end of the list.
• D.The ACL will require comments.

Refer to the output.

A technician implements a new N-Series switch and connects it to another N-Series switch with OSPF already configured. The OSPF neighbor does not show up after 5 minutes of waiting.
What is causing the issue?

• A.A different configured routing protocol is preventing the neighbor relationship.
• B.A hello interval mismatch is occurring.
• C.A virtual link for RIP has been configured on the other switch.
• D.A Layer 2 VPN service is running on the other switch.

A Dell Networking N-Series switch is directly connected to a wireless Access Point that requires access to VLANs 1, 10, and 20 configured on the switch.
Which two Port VLAN Modes can be used to meet the VLAN requirements? (Choose two.)

• A.General
• B.DVLAN Tunnel
• C.Access
• D.Private VLAN Host
• E.Trunk

A technician connects two N3024 switches with two cables for redundancy on an existing network. Spanning Tree is disabled.
What happens between the two switches?

• A.Switches load balance between the two links.
• B.The MAC address table is not updated on the switches.
• C.A broadcast storm occurs in the network
• D.The switches use the links in a Round Robin fashion.