Online Access Free DCPPE-200 Practice Test

An engineer is deploying a new server node into an existing chassis for a virtualization cluster. The existing cluster nodes have many modified BIOS settings to meet workload needs.
How should the engineer quickly deploy the new server node with matching BIOS settings?

• A.Use the iDRAC GUI to replicate from an existing server profile.
• B.Use the CMC Server Profiles to clone an existing server profile.
• C.Use System Setup to configure dynamic profile settings based on workload.
• D.Use the Lifecycle Controller to mirror a cluster member profile.

An engineer installs a second Shared PERC Internal card into a VRTX and is performing post installation tasks.
The Fault Tolerant Status is NOT Healthy/Normal as expected.
What is the cause?

• A.The Shared PERC cards are NOT at the same firmware level.
• B.The physical disks were removed from the chassis before initialization finished.
• C.The VRTX was NOT licensed for two Shared PERC Internal cards.
• D.One or more nodes are still assigned virtual disks.

An engineer needs to connect ports 49 and 53 on an MXL to a top of rack (ToR) switch in an LACP port channel.
The ToR switch has ports 46 and 60 configured in port channel 100.
Which configuration will successfully bring up the port channel on the MXL?

• A.interface Port-channel 1switchportinterface range fortyGigE 0/46, fortyGigE 0/60port-channel-protocol LACPport-channel 1 mode active
• B.interface Port-channel 1switchportinterface range fortyGigE 0/49, fortyGigE 0/53port-channel-protocol LACPport-channel 1 mode active
• C.interface Port-channel 100channel member fortyGigE 0/49, firtyGigE 0/53switchportinterface range fortyGigE 0/49, fortyGigE 0/53port-channel 100 mode active
• D.interface Port-channel 100channel member fortyGigE 0/49, fortyGigE 0/53switchportinterface range fortyGigE 0/49, fortyGigE 0/60lacp mode active

An engineer needs to re-purpose the storage of the chassis. Data must be lost when a drive fails. The configuration needs to allow for redundancy with the maximum amount of usable space.
What should the engineer create to perform this task?

• A.RAID 6
• B.RAID 5
• C.RAID 60
• D.RAID 50

An engineer is redeploying a blade chassis, and is logged into the CMC web interface. The engineer has configured the iDRACs for the blade servers.
When the engineer tries to log into one of the iDRACs, the connection fails. The engineer can ping the CMC from the engineer's workstation but can NOT ping the iDRACs. The engineer tries to ping the iDRAC IP from the CMC itself using the diagnostic tool, but that also fails.
Which two tasks should the engineer perform?

• A.Disable firewall service on iDRAC. Confirm subnet mask configuration on iDRAC.
• B.Update DNS servers for iDRAC. Check VLAN settings on the CMC and iDRAC.
• C.Enable IPv6 on the CMC and iDRAC. Disable firewall service on iDRAC.
• D.Confirm subnet mask configuration on iDRAC. Check VLAN settings on the CMC and iDRAC.