Free Access EMC.DES-5221.v2022-08-30.q29 Practice Test (Page 2)

Question 1

What is required to enable ECMP in BGP?

A.Sub-interfaces must be configured on the physical interface running BGP.

B.Maximum-paths and multipath-relax commands.

C.OSPF must install equal cost paths in the routing table for BGP to use ECMP.

D.ECMP is not possible in BGP.

Question 2

What is the default PIM-SSM IP range?

A.224.0.0.0/4

B.224.0.0.0/24

C.232.0.0.0/8

D.232.0.0.0/4

Question 3

How are multiple hardware based ACLs filtered?

A.NTP

B.DHCP

C.NPU

D.IP

Question 4

A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?

A.Spanning tree Loop-guard was implemented on the uplink-state group.

B.One of the upstream interfaces is an uplink-state group went down.

C.Both a port channel and its members were assigned to an uplink-state group.

D.There was no issue; this is normal behavior.

Question 5