Online Access Free FlashArray-Implementation-Specialist Practice Test

An Implementation Engineer is performing a FlashArray//XR4 to FlashArray//XL upgrade, and is preparing to remove the XR4 CT0 controller.
Which command should the Implementation Engineer run to stop Purity after confirming CT0 is the secondary controller?

• A.purehw controller stop --verify-array ARRAY_NAME ct0
• B.purewes controller disable --purity --verify-mode secondary --verify-array ARRAY_NAME ct0
• C.purewes controller setattr --disable --verify-mode secondary --verify-array ARRAY_NAME ct0
• D.purewes controller disable --purity --verify-mode primary --verify-array ARRAY_NAME ct0

How can an Implementation Engineer confirm for the customer that data-at-rest encryption is enabled on a newly installed FlashArray?

• A.Inform the customer that data-at-rest encryption is an always-on architecture feature and cannot be disabled.
• B.Provide output of the purearray encryption list --data-at-rest command showing status enabled.
• C.Provide output of the puresetup newarray command showing that RDL was enabled.
• D.Provide output of the puresecurity status command showing the number of encrypted sectors.

A FlashArray//XR2/3 has an Ethernet mezzanine (EMEZZ), what are the interface names of the ports on the mezzanine?

• A.ETH8, ETH9, ETH10, and ETH11
• B.ETH6, ETH7, ETH8, and ETH9
• C.ETH10, ETH11, ETH12, and ETH13

By default, which network interface does FA File use to resolve and reach domain controllers?

• A.replication
• B.filevip vif
• C.management

What are the interface names for a 4-port FC card in slot 1 in an XR2/3 array?

• A.FC4, FC5, FC6, and FC7
• B.FC0, FC1, FC2, and FC3
• C.FC5, FC6, FC7, and FC8