The following statement about IToIP is wrong is _______.

Regarding the Stub area and NSSA area of the OSPF protocol, the following statements are incorrect: _______

The RIP protocol is enabled on a router, the process number is 1, and the priority is 10; at the same time, the OSPF protocol is enabled, the process number is 100, and the priority is 100. If two processes learn the route of the 10.0.0.0/8 network segment at the same time, the metric values are 1 (hop count) and 100 (cost value), and the next hop is 1.0.0.1 and 1.0.0.2 respectively.
After the router receives a packet with a destination address of 10.0.0.1, how to deal with it?

As shown in the figure, the MSR router in the headquarters is connected to the branch through the Ethernet interface E1/0, and the connection is backed up through the ISDN network. Which of the following options is the most reasonable and feasible at this time?

The routing table on a H3C router is displayed as follows:
H3C]disp ip rout
Routing Table: public net
Destination/Mask Protocol Pre Cost Nexthop Interface
10.0.0.0/8 OSPF 10 2 20.1.1.2 Ethernet0/0
20.1.1.0/30 DIRECT 0 0 20.1.1.1 Ethernet0/0
20.1.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
172.16.1.0/24 DIRECT 0 0 172.16.1.1 LoopBack1
172.16.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
192.168.1.0/24 DIRECT 0 0 192.168.1. LoopBack2
192.168.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
At the same time, configure the following commands on the router:
bgp 65400
network 172.16.0.0
network 192.168.1.0
network 10.0.0.0
Based on the above information, which of the following BGP routes should be in the router's BGP routing table: