The administrator wants to configure the RIP routing priority value to be 60 on the MSR router. Which of the following commands is correct?

The router's IP routing table has an entry from 21.22.23.0/22. To import it into BGP, which of the following instructions should be used?

A network is connected to the Internet through a 64kbps wide area link. The customer requires that the bandwidth of this link is used as efficiently as possible.
You should use _______ to connect to the Internet.

In the topology shown in the figure, perform the following configurations on RTA, RTB, and RTC respectively:
RTA-GigabitEthernet0/0] ip address 192.168.2.1 255.255.255.0
RTA] ospf 1 router-id 1.1.1.1
RTA-ospf-1] area 1
RTA-ospf-1-area-0.0.0.1] network 192.168.2.0 0.0.0.255
RTB-GigabitEthernet0/0] ip address 192.168.2.2 255.255.255.0
RTB-GigabitEthernet0/1] ip address 192.168.3.1 255.255.255.0
RTB] ospf 1 router-id 2.2.2.2
RTB-ospf-1] area 1
RTB-ospf-1-area-0.0.0.1] network 192.168.2.0 0.0.0.255
RTB-ospf-1] area 0
RTB-ospf-1-area-0.0.0.0] network 192.168.3.0 0.0.0.255
RTB-ospf-1]import-route direct
RTC-GigabitEthernet0/0] ip address 192.168.3.2 255.255.255.0
RTC] ospf 1 router-id 3.3.3.3
RTC-ospf-1] area 0
RTC-ospf-1-area-0.0.0.0] network 192.168.3.0 0.0.0.255
Then the LSA types generated by RTB in the OSPF area are _______

h network as shown in the figure:
The main configuration of the router is as follows:
RouterA]
bgp 100
router-id 1.1.1.1
peer 1.1.1.2 as-number 300
network 4.4.4.4 24
network 5.5.5.5 24
network 6.6.6.6 24
RouterB]
bgp 200
router-id 2.2.2.2
peer 1.1.2.2 as-number 300
network 7.7.7.7 24
network 8.8.8.8 24
network 9.9.9.9 24
RouterC]
bgp 300
router-id 3.3.3.3
peer 1.1.1.1 as-number 100
peer 1.1.2.1 as-number 200
peer 1.1.3.2 as-number 400
RouterD]
bgp 400
router-id 4.4.4.4
peer 1.1.3.1 as-number 300
peer 1.1.3.1 route-policrt1 import
ip as-path 1 permit _200_
route-policrt1 dennode 1
if-match as-path 1
route-policrt1 permit node 2
Assuming that the IP addresses of the interfaces on the four routers have been correctly configured, if there is no problem with the link, check the BGP routing table of Router D, and you can see which of the following BGP routes are: