Question 31
The following commands are configured on the S3610 switch:
qos map-table dot1p-lp
import 1 export 5
interface Ethernet1/0/6
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos priori4
interface Ethernet1/0/7
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos gts queue 5 cir 12600 cbs 2000000
Then when the flow rate is 10Mbps the vlan id is 2 and 802.1p preferred priority of 1 is the packet from the port E1 / 0/6 enters only port E1 / 0/7 when forwarding.Then the following commands are configured on the following switches: the statement is correct
qos map-table dot1p-lp
import 1 export 5
interface Ethernet1/0/6
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos priori4
interface Ethernet1/0/7
port link-mode bridge
port link-tpe trunk
port trunk permit vlan 1 to 2
qos gts queue 5 cir 12600 cbs 2000000
Then when the flow rate is 10Mbps the vlan id is 2 and 802.1p preferred priority of 1 is the packet from the port E1 / 0/6 enters only port E1 / 0/7 when forwarding.Then the following commands are configured on the following switches: the statement is correct
Question 32
User behavior management needs to pay attention to the content of ________ .
Question 33
The CPE in the following options is ____ .
Question 34
Execute the command on the MSR router and output the following information:
Interface: GigabitEthernet0/1
Output queue: (Urgent queuing: Size/Length/Discards ) 0/100/0
Output queue: (Protocol queuing: Size/Length/Discards ) 0/500/0
Output queue: (Priorit queuing: PQL 1 Size/Length/Discards)
Top: 3/20/42878 Middle: 10/40/0 Normal: 60/60/259195 Bottom: 80/80/344297
Then the following statement is incorrect :
Interface: GigabitEthernet0/1
Output queue: (Urgent queuing: Size/Length/Discards ) 0/100/0
Output queue: (Protocol queuing: Size/Length/Discards ) 0/500/0
Output queue: (Priorit queuing: PQL 1 Size/Length/Discards)
Top: 3/20/42878 Middle: 10/40/0 Normal: 60/60/259195 Bottom: 80/80/344297
Then the following statement is incorrect :
Question 35
BGP MPLS VPN group network, private network packets from the CE side into the PE the device , PE how to determine the packet belongs to VPN_______ .