Free Access Huawei.H12-323_V2.0.v2026-11-11.q259 Practice Test (Page 5)

Question 16

Which of the following descriptions is correct about the relationship between power measurement units? (Multiple choice)

A.10dBm is equivalent to ten times the original power

B.If the power of A is 26dBm and the power of B is 20dBm, then it can be said that A is 6dBm greater than B.

C.-3dBm power is equivalent to one fifth of the original power

D.dB represents the relative value of power, 0dB represents the original power

Question 17

Which of the following descriptions about VRRP hot backup and dual-link hot backup are correct?
(Multiple choice)

A.VRRP hot backup only supports active-standby networking, not load-sharing networking, while dual- link hot backup supports active-standby and load-sharing networking.

B.During the VRRP hot backup active/standby switchback process, a smaller VRRP preemption delay time (usually less than 60 seconds) should be set to increase the active/standby switchover speed.

C.In VRRP hot backup, the AP only establishes one CAPWAP tunnel, while in dual-link hot backup, the AP needs to establish two CAPWAP tunnels.

D.VRRP hot backup supports backing up the IP address allocation information of the DHCP protocol, while dual-link hot backup does not support

Question 18

Which of the following functions can be implemented by the WLAN Planner? (Choose all that apply.)

A.Onsite signal scanning

B.3D simulation

C.Automatic AP deployment

D.Field strength simulation display

Question 19

Which of the following descriptions about dynamic load balancing used in high-density scenarios is correct? (Multiple choice)

A.Load balancing between APs, load balancing based on the number of access users or traffic, optimizes the distribution of terminals in the entire network and improves user experience

B.Dynamic load balancing can be divided based on the number of users, traffic, and business type.

C.Load balancing is applicable to high-density wireless network environments to effectively ensure the reasonable access of STAs. The purpose of 5G priority access within four APs is to reduce the 2.4CHz load and improve the overall performance of the system.

D.APs with load balancing enabled must be connected to the same AC, and STAs can scan the SSIDs of APs that perform load balancing.

Question 20

A company's WLAN network has multiple APs working in the 2.4G frequency band. Since there are relatively few available channels in the 2.46 frequency band, the recommended bandwidth is
20 MHz .

A.True

B.False

Premium Bundle

Newest H12-323_V2.0 Exam PDF Dumps shared by BraindumpsPass.com for Helping Passing H12-323_V2.0 Exam! BraindumpsPass.com now offer the updated H12-323_V2.0 exam dumps, the BraindumpsPass.com H12-323_V2.0 exam questions have been updated and answers have been corrected get the latest BraindumpsPass.com H12-323_V2.0 pdf dumps with Exam Engine here:

Access H12-323_V2.0 Premium Version

(713 Q&As Dumps, 40%OFF Special Discount: Exam-Tests)

Latest Upload: 114Juniper.JN0-281.v2026-11-11.q85; 113Lpi.010-160.v2026-11-11.q101; 111PECB.ISO-IEC-27002-Foundation.v2026-11-11.q39; 107Huawei.H12-323_V2.0.v2026-11-11.q259; 126Microsoft.AB-900.v2026-11-10.q89; 139Juniper.JN0-351.v2026-11-09.q113; 161NVIDIA.NCP-OUSD.v2026-11-09.q68; 148InsuranceLicensing.NY-Independent-General-Adjuster.v2026-11-07.q35; 161Salesforce.Analytics-Con-202.v2026-11-06.q31; 269PureStorage.FlashArray-Implementation-Specialist.v2026-11-06.q111