Online Access Free H12-721 Practice Test

Which of the following log categories does the firewall command output, content log, policy hit log, mail filter log, URL filter log, and audit log output from the firewall belong to?

• A.Session log
• B.Business log
• C.Packet loss logs
• D.System log

As shown in the figure is the firewall hot standby networking environment. In this networking environment, which of the following commands can ensure that the device automatically adjusts the priority of the VGMP management group and automatically performs the active/standby switchover?

• A.hrp ospf-cost adjust-enable
• B.hrp preempt delay 60
• C.hrp interface GigabitEthernet 0/0/2
• D.hrp auto-sync config

When the administrator assigns interface G1/0/0 to virtual system vsysa, it finds that the allocation fails. Which of the following reason is impossible?

• A.The G1/0/0 port has been allocated to other virtual systems.
• B.The interface has been added to the security zone of other virtual systems.
• C.This interface is a Layer 2 interface and cannot be directly assigned to a virtual system.
• D.The interface is not in the UP state.

About the configuration command in the smart routing, which statement of the following is correct? (Multiple Choice)
#
multi-interface
mode priority-of-link-quality
priority-of-link-quality parameter delay jitter loss
priority-of-link-quality protocol tcp-simple
add interface GigabitEthernet1/0/1
add interface GigabitEthernet1/0/2

• A.Use the way of bandwidth-based load sharing
• B.Selected 3 links for sharing
• C.Use the TCP protocol to detect
• D.Parameter of link quality detection has the delay, jitter, and packet loss rate

The following bandwidth policy configuration commands are available on Huawei's USG6000 products:
[USG] traffic-policy
[USG-policy-traffic] profile class1
[USG-policy-traffic-profile-class1] bandwidth maximum-bandwidth whole both 1000
[USG-policy-traffic-profile-class1] quit
[USG-policy-traffic] rule name policy1
[USG-policy-traffic-rule-policy1] source-zone trust
[USG-policy-traffic-rule-policy1] destination-zone untrust
[USG-policy-traffic-rule-policy1] source-address 192.168.1.0 mask 255.255.255.0
[USG-policy-traffic-rule-policy1] destination-address 192.168.2.0 mask 255.255.255.0
[USG-policy-traffic-rule-policy1] action cos profile class1
Which of the following statements are correct? (Multiple choices)

• A.192.168.1.0/24 hosts will be restricted from accessing 192.168.2.0/24 traffic
• B.Class1 defines the overall current limit and limits the 1000kbps
• C.The traffic matching Policy1 is directly released without restriction
• D.Match the traffic of Policy1 and control the flow of each source IP