The load sharing mode at both ends of the Eth-Trunk can be inconsistent.

What is the value of TPID defined by IEEE802.1Q?

The route entry 10.0.0.24/29 may be aggregated from which of the following subnet routes? (Multiple Choice)

The output information of a certain device is shown in the figure. Which of the following statements is correct? (Multiple Choice)
<Huawe1>display interface G1gabitEthernet 0/0/0
G1gabi tEthernet0/0/0 current state : UP
Line protocol current state : UP
Route Port, The Maximum Transmit Unit is 1000
Internet Address is 10.0.12.2/2 4
IP Sending Frames' Format is PRTFMT ETENT_2.Hardware address is 00e0- fc22- 4fff
Port Mode: FORCE COPPER
Speed : 100.Loopback: NONE
Duplex: FULL,Negotiation: DISABLE
Md1 : AUTO
Last 300 seconds input rate 24 bits/sec, 0 packets/sec
Last 300 seconds output rate 24 bits/sec, 0 packets/sec

On the broadcast network, both DR and BDR use the multicast address 224.0.0.6 to receive link state update messages.