Online Access Free H12-811 Practice Test

As shown in the figure, host A and host B want to implement inter-VLAN communication through single-arm routing. What configuration should be done under the G0/0/1.1 interface of RTA?()(Single-choice question)

• A.dotlq termination vid 30
• B.dotlg termination vid 1
• C.dotlq termination vid 10
• D.dotlq termination vid 20

The NAT configuration is as follows, which IP can be converted when accessing the public network (RTA) acl2000 (RTA-acl-basic-2000) rule5 permit source 192.168.1.00.0.0.255 RTA-acl- basic-2000) rule 10 deny source 192.168. 1.30 (RTA-acl-basic-2000) quit RTA) interface serial1/0/0 (RTA-Serial1/0/0) nat outbounD.2000*

• A.192.168.2.1
• B.192.168.1.2
• C.192.168.1.3
• D.192.168.1.1

Which of the following statements about VLANIF interfaces are correct? ()

• A.The VANIF interface does not need to learn MAC addresses.
• B.Different VLANIF interfaces can use the same IP address
• C.The VLANIF interface is a Layer 3 interface
• D.The VLANTF interface does not have a MAC address.

What is wrong about the ARP message? ()

• A.ARP request message is sent by broadcast
• B.ARP packets cannot be forwarded to other broadcast domains
• C.Any link layer protocol requires ARP protocol to assist in obtaining data link layer identification
• D.ARP reply message is sent by unicast party

The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

• A.The port type is Hybrid
• B.If the port receives a data frame without VLAN TAG, the switch needs to add VLAN TAG100
• C.If the VLAN TAG carried in the data frame is 100, the switch will strip off the VLAN TAG and send it out
• D.If the VLAN TAG carried in the data frame is 200, the switch will strip off the VLAN TAG and send it out