Question 36
Which of the following descriptions about wireless devices is correct?
Question 37
What kind of message does the DHCP server use to confirm that the host can use the IP address?
Question 38
The network management system can only view the operating status of the device through the SNMP protocol, but cannot issue configurations.
Question 39
The output information of a certain device is shown in the figure. Which of the following statements is correct? (Multiple Choice)
<Huawe1>display interface G1gabitEthernet 0/0/0
G1gabi tEthernet0/0/0 current state : UP
Line protocol current state : UP
Route Port, The Maximum Transmit Unit is 1000
Internet Address is 10.0.12.2/2 4
IP Sending Frames' Format is PRTFMT ETENT_2.Hardware address is 00e0- fc22- 4fff
Port Mode: FORCE COPPER
Speed : 100.Loopback: NONE
Duplex: FULL,Negotiation: DISABLE
Md1 : AUTO
Last 300 seconds input rate 24 bits/sec, 0 packets/sec
Last 300 seconds output rate 24 bits/sec, 0 packets/sec
<Huawe1>display interface G1gabitEthernet 0/0/0
G1gabi tEthernet0/0/0 current state : UP
Line protocol current state : UP
Route Port, The Maximum Transmit Unit is 1000
Internet Address is 10.0.12.2/2 4
IP Sending Frames' Format is PRTFMT ETENT_2.Hardware address is 00e0- fc22- 4fff
Port Mode: FORCE COPPER
Speed : 100.Loopback: NONE
Duplex: FULL,Negotiation: DISABLE
Md1 : AUTO
Last 300 seconds input rate 24 bits/sec, 0 packets/sec
Last 300 seconds output rate 24 bits/sec, 0 packets/sec
Question 40
Which of the following statement about MPLS Labe1 statement label is wrong?
