Free Access Huawei.H12-811_V1.0.v2026-05-20.q298 Practice Test (Page 51)

Question 246

Which packet type is used by network devices running the SNMPv1 protocol to actively send alarm information? ()

A.Trap

B.Get Request

C.Response

D.Get-Next Request

Question 247

As shown in the figure, when the switch needs to forward frames with the destination mac address of 5489-98ec-f011, which of the following descriptions is correct? () (Single-choice question)

A.The switch needs to send a request to discover the device with the mac address of 5489-98ec-f011

B.The switch will be All ports outside flood the frame

C.The switch did not find a matching entry in the mac address table. So the frame will be discarded

D.The switch will send a message that the destination is unreachable to the source device

Question 248

As shown in the figure, which of the following ports will be in a blocking state?

A.G0/0/2 of SWC

B.G0/0/3 of SWB

C.G0/0/1 of SWC

D.G0/0/3 of SWA

Question 249

Protocol Priority Switch A. and Switch B. adopt LACP mode link aggregation, and all interfaces join the link aggregation group. At the same time, set the maximum number of active ports to 3. Then which port of switch A is not an active port? ()

A.G0/0/3

B.B. G0/0/1

C.D. G0/0/0

Question 250

As shown in the following figure, in the switching network, all switches are running the stp protocol. When the topology is stable, which of the following switches can be used to modify the BPDU sending cycle. Can it affect the SWD configuration BPDU sending cycle? () (Single-choice question)