Question 11

To prevent loops on an STP network, after a designated port is elected, it must wait for a long time and can forward packets only after the status of all ports on the entire network is determined. To solve this problem, RSTP uses the P/A mechanism to speed up the downstream port's transition to the Forwarding state.
  • Question 12

    Both MQC and PBR can be applied on device interfaces to filter received and sent packets or control packet forwarding paths.
  • Question 13

    On the OSPF network shown in the figure, an adjacency has been established between R1 and R2. An engineer configures the commands in the figure on R2. In this case, which of the following routing entries may exist in the routing table of R2?
  • Question 14

    In the NetStream stream output mode, the advantage of the original stream output is that NSC can obtain detailed statistical information for each stream.
  • Question 15

    A route-policy consists of one or more nodes.
    What is the maximum number of nodes in a route-policy?