Free Access Huawei.H31-341-ENU.v2022-10-13.q154 Practice Test (Page 14)

Question 61

Which of the following description of the extended ECC is correct? (Multiple Choice)

A.The scale of the extended ECC network (the sum of the server and the client) must not exceed 8.

B.In the automatic extended ECC mode, you need to connect the Ethernet ports of the two NEs with a direct-connected network cable (or a standard network cable through B), extend the ECC, and specify the server and client.

C.Extended ECC recommends to use manual basis, which reduces mutual negotiation between network elements.

D.Extended ECC is divided into automatic extended ECC and manual extended ECC. One network element can only support one mode at the same time. These two methods cannot be directly docked.

Question 62

Which of the following are limitations of the alarm and performance analysis methods? (Multiple Choice)

A.In the case of complex networking, service, and fault information, many alarms and performance events may occur along with the occurrence of faults. Due to too many reports and performance events, maintenance personnel are unable to analyze.

B.Field maintenance personnel cannot understand the current operating condition of the equipment.

C.The network administrator cannot obtain the current notifications of the device, the alarm occurrence time, and the historical alarm of the device.

D.When some faults occur, there may be no obvious alarms or performance events reported, and sometimes no alarms or performance events are found.

Question 63

In the scenario where the non-convergence OTU processes OTN standard signals, both A and B are WDM sites.The OTU at station A accesses four channels of R_LOS signals on the client side. After being processed in the middle part and on the WDM side of the OTU at station A, the alarm signals are then sent to station B.
The ODUk_PM_AIS alarm of the corresponding channel is generated in the middle part of station B.
The ODUk_PM_AIS alarm is detected in the client device.

A.True

B.False

Question 64

Which of the following SOM systems is not monitored?

A.Receive OTU input optical power

B.Main light path performance

C.Type of originating FEC

D.Light performance flatness

Question 65

The following description of the connection of the NG WDM device to the network management computer, which is wrong?

A.If the subrack connection mode is master-slave mode, the network management computer must be connected to the main subrack.

B.Only the gateway network element needs to be connected to the network management computer.

C.The connection network management computer can be connected either directly or through a local area network, as the case may be.

D.All network element IP addresses must be in the same address segment as the network management computer IP address.

Other Version: 4042Huawei.H31-341-ENU.v2022-05-23.q144; 3352Huawei.H31-341-ENU.v2022-03-27.q123

Latest Upload: 140Fortinet.NSE7_SSE_AD-25.v2026-09-05.q85; 192Microsoft.PL-400.v2026-09-05.q375; 303Snowflake.DEA-C01.v2026-09-04.q215; 195HP.HPE0-V27.v2026-09-04.q127; 291NAHQ.CPHQ.v2026-09-03.q481; 124SAP.C-S4CPB-2602.v2026-09-02.q7; 138Cisco.700-805.v2026-09-02.q86; 171MSSC.CLT-4.0.v2026-09-02.q43; 135Fitness.NCSF-CPT.v2026-09-02.q18; 205Google.Generative-AI-Leader.v2026-09-02.q77

Question 61

Question 62

Question 63

Question 64

Question 65

Download PDF File