Online Access Free HP0-Y47 Practice Test

Refer to the exhibit.

The current software on the Intelligent Resilient Framework (IRF) virtual device shown in the exhibit is version 1104. The network administrator wants to upgrade to software version 1105.
What will happen when the administrator attempts to use In-Service Software Upgrade (ISSU) for this upgrade?

• A.When the administrator executes the switch over to the new master, a rollback will occur, causing the software to revert to the previous version.
• B.When the administrator executes the switchover to the new master, an outage will occur while this master reboots.
• C.The process can complete successfully. Some links might go down, causing temporary failovers within link aggregation groups.
• D.The IRF virtual device will not accept the ISSU commands. It will output various error messages.

An HP Provision switch port is implementing MAC Authentication (MAC-Auth) to a RADIUS server. A device connects to the port, and the switch submits a RADIUS Access-Request to the server. What correctly describes how the switch determines the username and password for the request?

• A.The switch always sends the device MAC address as the username and the password, and this behavior cannot be reconfigured.
• B.Depending on the configuration, the switch sends the device MAC address for the username or a configured username. It sends the device MAC address for the password or a configured password
• C.The switch always sends the device MAC address as the username. Depending on the configuration, the password is the device MAC address or a configured password.
• D.The switch always sends the device MAC address as the username. It always sends "provision" for the password, and this password cannot be reconfigured.

For which use case is a basic or standard access control list (ACL) appropriate?

• A.Controlling which devices can access other devices based on the source VLAN tag
• B.Controlling which devices can access other devices based on the MAC addresses
• C.Controlling which devices can access other devices based on the IP addresses
• D.Controlling which devices can access other devices based on the IP protocol number

Refer to the exhibit.

These three routers are currently configured for BGP. They do not apply any routing policy in terms of BGP on routes or attributes advertised to an received from peers. How can the network administrator for Router 1 cause Router 1 to advertise 192.0.2.0/24 to Router 2
and Router 3?

• A.Apply route policy 1 as an inbound policy for both peers
• B.Apply route policy 1 as an outbound policy for both peers
• C.Enable BGP routing on RAGG1
• D.Add a null route to 192.0.2.0/24

Refer to the exhibit.

This HP 10500 Switch Series is receiving an average of 1 Gbps of HTTP traffic from 10.1.4.0/24. The switch starts to receive an additional 1 Gbps of HTTP traffic from 10.1.4.0/24. How does the switch handle the traffic?

• A.It forwards the traffic but marks it yellow (for a higher drop precedence)
• B.It forwards the traffic but marks it for forwarding in a lower priority queue
• C.It forwards the traffic without remarking it in any way
• D.It drops the traffic