Online Access Free HP0-Y49 Practice Test

Refer to the exhibit.
Exhibit Comware switch output.

A network administrator has implemented link aggregation on an HP Comware switch using LACP. Assume the two ports are functioning at the data link layer between the Comware switch neighboring switch. The network administrator execution display link-aggregation verbose command and notices the flag of AG for the two links. As shown in the exhibit.
What does this indicate?

• A.The link is marked as a backup because there are already eight active links in the aggregation
• B.The link is up, but LACP has been disabled on the port.
• C.The link is down
• D.The link is up, but LACP failed the negotiation on the port

Which open standard allows a switch with PoE support to correctly determine the power requirements of a connected device?

• A.AutoPower
• B.CDP
• C.LLDP-MED
• D.ICMP

Which technology does the HP Virtual Connect support?

• A.Fibre Channel over Ethernet (FCoE)
• B.Intelligent Resilient Framework (IRF)
• C.Distributed trunking
• D.InfiniBand connection to server backplane

Refer to the exhibit.
Exhibit: Network diagram and routing tables Why does traffic from PC1 fail to reach PC2?

• A.The subnet mask is incorrect on the routers
• B.There is no route back from router B
• C.A default gateway setting is incorrect
• D.Only static routes have been enabled

A network administrator is trying to determine the topology once MSTP has been enabled on an HP switch A switch in the topology has two paths to the root, where the accumulated path cost is the same for both paths What is the next criterion used to determine which port should be the root port?

• A.Port with the highest priority
• B.Port with the lowest priority
• C.Port connected to the neighbor with the lowest bridge ID
• D.Lowest port number