Online Access Free HP2-Z18 Practice Test

You must configure port GigabitEthernet 1/0/1 on an HP A-Senes switch so that it can support policy-based VLANs and port-based VLANs Which type of port is required to support this configuration?

• A.hybrid
• B.access
• C.tagged
• D.trunk

What is the default load-balancing behavior for Layer 2 traffic forwarded over aggregated links on an HP A-Series switch?

• A.Load-balancing is based on the source MAC address and egress port
• B.Load-balancing is based on the source MAC address and the destination MAC address.
• C.Load balancing is based on the source MAC address only.
• D.Load-balancing is based on the destination MAC address only.

You must enable Secure HTTP (HTTPS) to encrypt web-based management traffic on an HP E-Series switch. The switch is at default settings. What must be installed or enabled to apply this solution?

• A.web server
• B.internal RADIUS server
• C.digital certificate
• D.encryption accelerator

What is the VLAN status of the ports on an HP A-Series switch at factory default settings?

• A.All ports are trunk ports using VLAN 1 as their default VLAN
• B.All ports are access ports using VLAN 1 as their default VLAN.
• C.VLANs are unassigned until a port mode is defined.
• D.All ports are in a learning state waiting for VLAN assignment through GVRP.

Which HP E-Series switch models display the following prompt in the interface configuration context? (Select two)
HP Switch (eth-A24)#

• A.E5412-96GZI
• B.E8212zl
• C.E350CM8G-POEyI
• D.E2910-24Gal
• E.E6600-24G