Online Access Free HP2-Z34 Practice Test

Refer to the exhibit

An administrator is setting up this data center topology to use SPBM VMs in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2 from other subnets. On which Switch 1 interfaces should the administrator enable SPBM?

• A.VLAN interfaces 10, 20, and 30
• B.interfaces Ten1/0/1-Ten1/0/48 and interfaces Forty1/0749-1/0750
• C.interfaces Forty 1/0749-1/075E only
• D.VLAN interfaces 101 and 103

Refer to the exhibit

A VSAN is being set up on an HP Comware switch that will connect to server Converged Network Adapters (CNAs) and storage systems The administrator is checking the configuration of the VSAN with display commands The exhibit shows the results.
What is a potential issue?

• A.The domain ID has been set manually to a preferred ID, but this switch does not have the highest priority
• B.The current zoning configuration does not permit any communication.
• C.The fabric name has been set to the same ID as the switch WWN. which causes conflicts.
• D.The distribute mode for zones has been set to active only, which can cause issues with redundancy.

An administrator is configuring an HP switch to run SPBM. Which Spanning Tree Protocol (STP) configuration is required?

• A.Ensure that the switch with the lowest IS-IS router ID has the lowest bridge priority.
• B.Map all B-VLANs to MSTP instance 4092
• C.Set the spanning tree mode to ECT.
• D.Disable STP.

Refer to the exhibit

The company wants to use TRILL in the backbone links shown in the exhibit. Servers use VLANs 10, 20,and 30 and should be able to communicate across the backbone. On which Switch 1 interfaces should the administrator enable TRILL?

• A.interfaces Forty1/0/49 and Forty1/0/50 only
• B.VLAN interfaces 1,10, 20, and 30
• C.VLAN interface 1 only
• D.interfaces Ten1/0/1 to Ten1/0/48, and Forty1/0/49 and Forty1/0/50

Refer to the exhibit

An administrator is creating the EVI network shown in the exhibit Switches 1 and 2 are configured as ENDP servers. and Switch 3 is configured as an ENDP client to the ENDP servers. Which configuration is correct for the EVI tunnel interface on Switch 3?

• A.The source IP address is the switch router ID; no other destination IP addresses need to be set.
• B.The source IP address is the address on the connection to the service provider; the addresses for switches 1, 2, and 4 need to be set as destinations
• C.The source IP address is the address on the connection to the service provider; no other destination IP addresses need to be set.
• D.The source IP address is the switch router ID; the addresses for switches 1. 2. and 4 need to be set as destinations