Online Access Free HP2-Z37 Practice Test

Refer to the exhibit.

Switch-1,an HP Comware switch, is connected to Switch-2,an HP ProVision switch on a link aggregation. The exhibit shows the link aggregation status on both sides of the link. Based on the exhibit, what is the behavior that the network administrator should expect?

• A.Only one of the links in the link aggregation can successfully forward traffic. Switch-2 assigns some traffic to the other link, which causes connectivity issues.
• B.Both links in the link aggregation can successfully forward traffic, so all bandwidth is available and no connectivity issues occur.
• C.Only one of the links in the link aggregation can successfully forward traffic. Switches assign all traffic to that link, so bandwidth is limited but no connectivity issues occur.
• D.Neither link in the link aggregation can successfully forward traffic, so the switches have no connectivity between them.

Refer to the exhibit.

All of the switches in the exhibit are running Multiple Spanning Tree Protocol (MSTP). The ports that connect to another switch are not boundary ports. All switches are configured as follows:
Config name = Region 1
Revision number = 1
Instance 1 =VLANs 10 and 12
Instance 2 = VLANs 11 and 13
Currently, only VLANs 1, 10, 11, 12,and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

• A.The ports that connect to other switches on Switch_C become boundary ports.
• B.No topology changes occur with spanning tree.
• C.Switch_C enters a spanning-tree inconsistent state and blocks all ports.
• D.Link load sharing is no longer in effect on Switch_C.

Refer to the exhibit.

A network administrator is managing the configuration files on an HP Provision switch and executes the commands shown in the exhibit. What is the probable cause of the error message when the administrator tries to copy the file?

• A.The copy command should only be used to manage operating systems.
• B.The flash memory in the switch is full and supports no more files.
• C.No empty configuration memory slots exist on the switch.
• D.The copy command contains a syntax error.

A network administrator copies new software to the secondary slot on an HP Provision switch and attempts to configure the switch to boot with the secondary software. Which command should the administrator use to verify that the appropriate changes were made?

• A.show version
• B.show system
• C.show flash
• D.show startup

A network administrator has started configuring DHCP relay on an HP Comware switch with these commands:
[Switch] dhcp enable [Switch] interface vlan 10 [Switch-Vlan-interface10] dhcp select relay
What else must the administrator do to finish configuring DHCP relay?

• A.Configure a DHCP server group globally and specify the server group on the VLAN 10 interface.
• B.Configure the DHCP server address on the VLAN 10 interface and enable DHCP services on the VLAN interface.
• C.Configure a DHCP server pool and add the DHCP relay option to the pool
• D.Configure a DHCP server pool and enable the DHCP server globally.