Online Access Free HPE0-S50 Practice Test

A customer has the following HPE Synergy solution:
* Three Synergy frame
* two HPE Virtual SE 16Gb Channel modules in each frame
* two HPE Virtual Connect interconnect Link Modules
* Four HPE Synergy 10Gb Interconnect Link Modules
Click the menu option the Synergy integrator should use to add uplinks from HPE Virtual Connect SE 16Gb FC modules to SAN switches.

Correct Answer:

Explanation

Storage SAN

A Synergy integrator needs to add more to a server profile.
What does the integrator need to be aware of performing this action?

• A.The host networks will go offline the when the profile is assigned.
• B.The Virtual Connect modules needs to be reboot once the profile applied.
• C.The host needs to be powered off to active the change.
• D.The server profile must be changed before modifying the server profile.

A customer is planning an HPE Synergy solution with 20 frames an needs to minimize the number of management ports that are required to connect the frames into the existing management network.
Which procedure should the Synergy into a integrator use to address the customer's concern?

• A.Connect the RJ-45 front port of each frame to two external switches for redundancy: Then connect the uplink from the two switches into the customer's management network.
• B.Connect FLMs from all frames into a management ring: Then connect the management ring to the customer's management network using two uplinks.
• C.Connect the RJ-45 front ports of each frame to an external switch. Then connect the uplink from the external switch into the customer management network.
• D.Connect FLMs from all frames to two external switches for redundancy: Then connect the two uplinks from the two switches into the customer management network.

A customer has moved a USB bootable drive to another compute module but the compute module fails to boot from the USB device.
What should the Synergy integrator do to resolve this issue?

• A.Make sure PXE boot is disabled.
• B.Verify that the USB drive key is enable in UEFI system Utilities.
• C.In the server Profile. make sure OS Deployment is set to Deployment plan.
• D.Use UEFI System Utilities to disable the B1401 RAID controller.

While troubleshooting a hardware issue, a Synergy integrator needs to provide HPE Support with a new support dump.
What must the integrator be aware of when generating a support dump?

• A.Root level privileges are required to create a support dump.
• B.When creating a new support dump, the previous support dump is deleted.
• C.Only two support dumps can exist on an application at any one time.
• D.Management tasks are suspended during support dump creation