Online Access Free HPE0-Y53 Practice Test

Refer to Exhibit:

Assume that the switches in the MPLS region are correctly configured with OSPF, MPLS, and LDP. They are using liberal retention mode for labels.
The network administrator wants LSP convergence to occur as quickly as possible in case one of the redundant links fails. What should the administrator do on each MPLS switch?

• A.Enable MPLS ECMP
• B.Tune OSPF convergence.
• C.Change the label retention mode to conservative.
• D.Configure redundant remote LDP sessions.

Refer to Exhibit:

A network administrator is configuring an MPLS and VPLS Martini to connect customer Sites 1, 2, and 3. The administrator has created Virtual Switch Instance (VSI) "CustomerA" for this purpose. How should the administrator connect customer Site 1 to the VPLS solution?

• A.Create a service instance on the VLAN assigned to g1/0/1. Bind (cross-connect) that instance to the CustomerA VSI.
• B.Create a service instance on g1/0/1. Also create a global cross-connect group, and bind the CustomerA VSI and the service instance in that group.
• C.Create a service instance on the VLAN assigned to g1/0/1. Also create a global cross-connect group, and bind the CustomerA VSI and the service instance in that group.
• D.Create a service instance on g1/0/1. Bind (cross-connect) that instance to the CustomerA VSI.

Refer to Exhibit:

A network administrator has set up MPLS on the switches shown in the exhibit. The administrator wants to verify that PE-1 can use MPLS to forward traffic to Site 3, as well as seethe labels used along the path. Which step should the administrator take to obtain this information?

• A.Use thedisplaycommand to view MPLS LDP neighbors.
• B.Debug LDP and ping an IP address at Site 3.
• C.Use thedisplaycommand to view MPLS Label Forwarding Information Base (LFIB).
• D.Run a tracert to an IP address at Site 3 using the MPLS option.

A company is using MCE to create a multi-tenant data center solution. Network administrators want to isolate all management functions in a VPN instance "Management". Each switch has an IP address in 10.0.2.0/24 on its Management Ethernet port, and HP IMC manages the switches on these IP addresses. Administrators assign the Management Ethernet interfaces to the "Management" VPN instance. IMC begins losing data from the switches.
How should administrators fix the problem on each switch?

• A.specify VPN instance "Management" for management settings such as SNMP trap destination.
• B.Set VPN instance "Management" as the default VPN instance.
• C.Enable route leaking globally.
• D.Create a static or dynamic route to 10.0.2.0/24 in the public VPN table.

Refer to Exhibit:

A network administrator wants to create a leaf and spine topology. How should the administrator connect the switches for the best latency and load-balancing?

• A.Connect each leaf switch to each spine switch, and run a protocol such as EVI.
• B.Connect each leaf switch to half of the spine switches, and run a protocol such as TRILL.
• C.Connect each leaf switch to each spine switch, and run a protocol such as TRILL.
• D.Connect each leaf switch to half of the spine switches, and run a protocol such as EVI.