A.Additional uplink ports can be added to ETH-Uplink to increase available bandwidth.

B.The maximum supported number of the internal networks for logical interconnect is configured.

C.For FC uplink sets, an additional uplink from second module should be added for redundancy.

D.FC uplinks are not supported and will be converted to FCoE or RoCE uplinks.

A.A logical enclosure is created automatically, and it is always based on a single enclosure.

B.A logical enclosure can have between 1 to 5 HPE BladeSystem c7000 enclosures.

C.A logical enclosure can contain a mix of HPE BladeSystem c7000 and C3000 enclosures.

D.A logical enclosure must be created only for monitored HPE BladeSystem C700O enclosures.

A.RoCE networks are not supported with HPE BladeSystem

B.RoCE networks require Virtual Connect SE 32Gb FC Modules.

C.RoCE networks are supported only when PVLANs are enabled.

D.RoCE networks cannot be configured when Virtual Connect modules are used.

A.The backup user role must be used to extract the support dump

B.The support dump is encrypted and cannot be unpacked

C.The support dump for Logical Enclosure can be analyzed only using special tool.

D.The support dump does not have a valid HPE OneView certificate

A.Imported volumes are treated as private volumes and can be only used as boot volumes

B.A snapshot for imported volumes can be created only by using array management tools

C.Volumes imported to HPE OneView is managed just like a volume created using HPE OneView

D.Volumes imported to HPE OneView cannot be removed using the HPE OneView interface