Online Access Free HPE2-Z39 Practice Test

An ArubaOS switch operates at factory defaults and has a reachable IP address. How can network administrators access the switch CLI ?

• A.from the console port without authentication, but not from Telnet at all
• B.from the console port with the default username and password, but not from Telnet at al
• C.from the console port without authentication or from Telnet with the default username and password
• D.from the console port without authentication or from Telnet without authentication

A switch receives a broadcast frame in VLAN 2 on link aggregation, trk 1. How does the switch handle the broadcast?

• A.It floods it out all interfaces that are assigned to VLAN 2. including all links in trk1 except the link on which the broadcast arrived.
• B.It floods it out all interfaces that are assigned to VLAN 2. including one designated link in trk1.
• C.It floods it out all interfaces that are assigned to VLAN 2. including all links in Mel.
• D.It floods it out all interfaces that are assigned to VLAN 2 except any interfaces assigned to trk 1.

Switch-1 and Switch -2 have the Virtual Switching Framework (VSF) settings shown in the exhibits.
The administrator then connects the switches together on the interfaces in the VSF link.
The administrator first enables VSF on Switch-1 and confirms the reboot. After
Switch-1 reboots, the administrator enables VSF on Switch-2 and confirms the reboot.
What happens?

• A.Switch-1 and Switch-2 form a VSF fabric, and Switch-2 becomes the commander.
• B.Switch-1 and Switch-2 form a VSF fabric, and all interfaces on Switch-1 are disabled.
• C.Switch-1 and Switch-2 fail to form a VSF fabric, and al interfaces on both switches remain up.
• D.Switch-1 and Switch-2 form a VSF fabric, and Switch-1 becomes the commander.

What is a best practice for an MSTP region?

• A.The config name should contain the hostname of the root switch.
• B.Switch-to-switch links should carry all VLANs in use in the MSTP region.
• C.A switch should have a consistent spanning tree priority in each MSTP instance
• D.The desired root for the CIST should have a lower config revision than any other switch.

A network administrator accesses a new ArubaOS switch, Switch-1, through the console port and configures static IP address. 10.1.1.10/24, on VLAN 1. Besides this, the switch is at factory default settings. The administrator then connects Switch-1 as shown in the exhibit and tries to establish an SSH session to the switch from Device 1. The attempt fails.
What should the administrator do to resolve the connection failure?
****Exhibit is Missing****

• A.Configure Switch-2 to place the interface that connects the Switch-1 in VLAN 2.
• B.Create a default route through 10. 1.1.1. or set a default gateway on Switch-1
• C.Change the IP address of Device 1 to be an address in VLAN 1.
• D.Configure an operator or management password on Switch-1.