Online Access Free HPE2-Z40 Practice Test

What is one requirement to combine Aruba 5400R zl2 Series switches in a Virtual Switching Framework (VSF) fabric?

• A.One of the switches must be an Aruba 5412R switch, while the other member can be any switch in the 5400R series.
• B.The switches must operate in v3-module only mode; any modules of an earlier version are automatically disabled.
• C.The interfaces assigned to the VSF link must be pre-configured as part of a link aggregation.
• D.Both of the members must have two management modules.

A company requires wireless services at a mid-sized campus. Which advantage do Aruba Instant Aps
(IAPs) provide for such an environment?

• A.They operate as thin APs that are automatically discovered and controlled by a mobility controller.
• B.They are plug-and-play unmanaged APs that automatically support secure WLAN settings.
• C.They include an embedded version of Aruba AirWave that makes them easy to deploy and manage.
• D.They are controlled from a single interface without requiring the deployment of a separate controller.

Which solution provides firmware update automation for Aruba APs and switches?

• A.Aruba AirWave
• B.Aruba Activate
• C.Aruba Virtual Switching Framework (VSF)
• D.Aruba ClearPass

A network administrator needs to reach an ArubaOS switch CU at a management IP address The administrator also needs to ensure that the switch entirely rejects Telnet and SSH connections from users in data VLANs. How can the administrator meet these goals?

• A.Configure the management IP address on the default VLAN and set a manager password.
• B.Configure the management IP address on the OOBM port and configure the switch to listen for Telnet and SSH only on this port.
• C.Configure the management IP address on a VTY interface and bind an ACL to this interface.
• D.Configure the management IP address on any VLAN except the default VLAN. Set a manager and operator password .

A network administrator needs to configure Virtual Switching Framework (VSF) for the first time on an
ArubaOS switch The administrator enters this command:
Switch-1(config)# vsf member 1 link 1 a23, a24
The administrator then wants to provision member 2 settings. What must the administrator do before provisioning these settings?

• A.Specify the model type for member l.
• B.Configure SNMP settings that match settings configured on member 2.
• C.Enable VSF on the switch and reboot.
• D.Join member 2 to the VSF fabric.