Online Access Free HPE6-A40 Practice Test

Refer to the exhibit.

A network engineer reviews the HA redundancy configuration of the Master and Local controllers shown in the exhibit. The engineer notices HA preemption is not enabled.
Which statement are correct? (Choose two.)

• A.The CAPs in the ap group of Cluster-A can failover to 10.10.10.1.2 and will start to fall back to
  10.10.10.1 after 10.10.10.1 is up for 30 seconds.
• B.The RAPs in the ap group of Cluster-A can failover to 10.10.10.1.2 and will start to fall back to
  10.10.10.1 after 10.10.10.1 is up for 30 seconds.
• C.The CAPs in the ap group of Cluster-A can failover to 10.10.10.1.3 and will not fallback the original controller after 10.10.10.1 is up.
• D.The RAPs in the ap group of Cluster-A can failover to 10.10.10.1.3 and will start to fall back to
  10.10.10.1 after 10.10.10.1 is up for 30 seconds.

Refer to the exhibit.

A network administrator troubleshoots a problem with VLAN 63 on a controller. The controller's output is shown in the exhibit.
What should the network administrator do to bring VLAN 63 up on the controller?

• A.Create VLAN 63 on the controller
• B.Create Interface VLAN 63 on the controller
• C.Execute the operate up command under the VLAN 63 interface to start up the VLAN 63 protocol
• D.Execute the no shutdown command under the interface VLAN 63.

Which settings should be enabled on a firewall policy and applied to a role for voice devices to follow best practices? (Select two.)

• A.Deny other traffic except SIP
• B.Mark L2/L3 Qos tag if needed
• C.Deny all station to station access
• D.Allow access to Internet
• E.High Queue for voice traffic

An Aruba 7205 controller functions as a standby master: How many Campus Aps can it control while in standby mode?

• A.256
• B.0
• C.128
• D.512

Refer to the exhibit.

The network shown in the exhibits is configured with an active and standby controller that uses Layer 3 redundancy for AP termination. There are 100 APs provisioned into the AP Group NY1. The active local controller fails and the APs terminate on the standby local controller. Centralized licensing is enabled on the controller cluster with capacity for 100 APs. The WLAN clients are not able to SSID.
What could be the source of the problem?

• A.There are not enough licenses on the standby local controller lo support the APs.
• B.The uplink trunk of the standby controller does not permit the user VIANs for the SSIO Layer 3 deployment.
• C.The VLAN mapping is not configured on the standby local controller.
• D.The IP helper address on the interface VLAN AN is not configured on the standby local controller