Online Access Free HPE6-A45 Practice Test

Refer to the exhibit.

Every switch shown in the exhibit is an AOS-Switch that runs PIM-SM. A network administrator wants to load-balance the RP role, so Switch-3 and Switch-4 both act as RPs for some of the multicast groups. How should the administrator configure the RPs?

• A.Specify 10.3.3.3 as a static RP address on Switch-1. Specify 10.4.4.4 as a static RP address on Switch-2.
• B.Specify the candidate RP command on Switch-3. Also specify the candidate RP command on Switch-4.
• C.Specify 10.3.3.3 as a static RP address on half of the AOS-Switches and 10.4.4.4 as a static RP address on the other half.
• D.Specify Switch-3 and Switch-4 IP addresses as candidate RP addresses on Switch-1. Specify the same candidate addresses on Switch-2.

Refer to the exhibits:
Exhibit 1

Exhibit 2

A network administrator at a university notices high utilization on links between the access layer and core. The output shown in the exhibit is characteristic of samples taken several times an hour during congestion. The administrator suspects file sharing and other unauthorized traffic, and decides to use an ACL to permit only HTTP, HTTPS, and a few other authorized types of traffic.
How can the administrator apply the ACL to address both the security and the congestion problem?

• A.as an inbound VACL on the student VLAN on Switch-1
• B.as an inbound PACL on the link aggregations on the access switches
• C.as an inbound PACL on the link aggregations on Switch-1
• D.as an inbound VACL on the student VLAN on the access switches

Refer to the exhibit.

The network administrator wants to reduce failover time if a switch link in VLAN 100 goes down. What should the administrator do?

• A.Lower the dead timer on the BDR of VLAN 100.
• B.Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.
• C.Configure graceful restart on all of the OSPF routing devices on VLAN 100.
• D.Lower the hello timer only on the BDR of VLAN 100.

A network administrator needs to control traffic based on TCP or UDP application, as well as IP protocol, such as GRE or ICMP. What should the administrator configure for this purpose?

• A.both a standard IP ACL and an extended MAC ACL
• B.an extended IP ACL only
• C.both a standard IP ACL and a standard MAC ACL
• D.a standard IP ACL and an extended MAC ACL only

Refer to the exhibit.

A network administrator sets up prioritization for an application that runs between Device 1 and Device 2.
However, the QoS for the application is not what the administrator expects.
How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?

• A.Clear interface statistics on the switches. Then, run the application and check the interface queue statistics for the switch-to-switch links.
• B.Run a packet capture on Device 1, run the application, and look in the packet capture for a high value DSCP in the IP header.
• C.Set up RMON alarms on the switches that trigger when a high number of packets are dropped. Then, run the application and check for the alarm.
• D.Run a packet capture on Device 2, run the application, and look in the packet capture for a high value DSCP in the IP header.