An architect simulates VoIP calls and tests the throughput as 67 Kbps, packet loss as 0.3 percent, maximum
latency as 100 ms, and maximum jitter as 100 ms. Which issue typically causes a poor experience for users?

A customer needs a wireless solution upgrade. Among the devices that need wireless access are printers. What information about the printers does the architect need to plan the wireless solution? (Select two.)

Refer to the exhibit.

An architect needs to plan a network solution for a new office building with four floors. Each floor has two
wiring closets with the equipment shown in the exhibit. The switches will connect to employee desktops, a few
campus APs controlled by MCs, and printers. The switches do not implement tunneled node.
What is a best practice design for the VLANs and subnets for the wired devices?

A customer needs a wireless refresh for 802.11ac. The customer site has about 3,000 wireless devices, and the network architect plans to propose 200 APs. The architect also plans to propose two Virtual Mobility Controllers (VMCs) and a Virtual Mobility Master (VMM). Which licenses should the architect propose for this solution?

Refer to the exhibit.

The customer needs to expand its wired and wireless network to a new building, Building 2, which is near the
existing building, Building 1. The exhibit shows the logical plan that the architect has created so far. The
aggregation layer switches in the new building should provide the default gateway services for the VLANs in
the new building and route traffic to the core. The existing Aruba Mobility Controllers (MCs) will control the
new APs.
What should be the VLAN assignment for Link 1, indicated in the exhibit?