Online Access Free HPE6-A69 Practice Test

A customer is installing a new ArubaOS-CX switch The customer does not change the factory default QoS configuration The switch receives an 802.1Q tagged VOIP frame on a port The header contains a DSCP value of EF(46) and the frame has an 802 ip value of 5 How will the switch forward the frame?

• A.Forwards it based on the DSCP value in the frame
• B.Forwards the frame with best effort forwarding
• C.The switch trusts the settings and It forwards the frame with the current settings
• D.Forwards it based on the 802 ip value in the frame

When applying me following access-Iist to an ArubaOS-CX 6300 switch:

How does this ACL behave on the selected switch? (Select two.)

• A.The mp traffic to MANAGEMENT-SERVERS group is logged to me event logs
• B.The denied tcp traffic to the MANAGEMENT-SERVERS group is logged to event logs.
• C.The tftp traffic to MANAGEMENT-SERVERS group is not logged to the event logs.
• D.The snmp-trap traffic to MANAGEMENT-SERVERS is logged to the event togs.
• E.The denied tcp traffic to the MANAGEMENT-SERVERS group is not logged to event logs

The customer has a requirement for creating security filtering for IPv4 and IPv6 traffic passing through an ArubaOS-CX 6400 switch. Which statement Is true about access-list on the selected switch model?

• A.IPv4 and IPv6 entries can be used in one ACL with separate rules
• B.Separate IPv4 and IPv6 ACLs need to be created for inbound and outbound traffic
• C.Only one inbound or outbound ACL can be bound to an interface.
• D.Routed interfaces can have only inbound ACLs

What are the requirements for managing a switch using Aruba NetEdit? (Select two)

• A.Telnet must be disabled on the switch
• B.HTTPS service must be restricted to the management VRF
• C.REST access-mode must be set to read-write.
• D.The switch user account mat NetEdit uses should have a password.

Refer to the exhibit.

A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?

• A.Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.
• B.Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.
• C.Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.
• D.Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports