Online Access Free HPE6-A71 Practice Test

Refer to the exhibit.

Two Aruba Mobility Controllers (MC) are managed by a Mobility Master (MM) in a non-cluster deployment as shown in the exhibit.
* The C1 controller is connected to AP1 and AP2.
* The C2controller is connected to AP3 and AP4.
* VLAN mobility is enabled in the VAPs of both AP Groups.
* Both C1 and C2 support the same VLANs.
* User1's wireless device supports BSS Fast Transitioning and is currently connected to AP1.
What happens if User1 roamsacross the network and the user's device associates to AP3?

• A.User1's traffic is tunneled to the C1 controller, where they will not have to re-authenticate and can keep their original IP address.
• B.User1's traffic is terminated on the C2 controller, and they will have to re-authenticate and can keep their original IP address.
• C.User1's traffic is terminated on the C2 controller, and they will not have to re-authenticate but will need to obtain a new IP address.
• D.User1's traffic is terminated on the C2 controller, and they will have to re-authenticate and re-obtain a new IP address.

An administrator wants to dynamically upgrade AppRF on Aruba Mobility Controllers (MC) in a cluster. The administrator does not want to reboot the system at the time of the upgrade.
What should the administrator use for this upgrade?

• A.Aruba image
• B.Upgrade Profiles
• C.Cluster Upgrade Manager
• D.Loadable Service Module (LSM)

An administrator deploys an AP at a branch office. The branch office has a private WAN circuit that provides connectivity to a corporate office controller. An Ethernet port on the AP is connected to anetwork storage device that contains sensitive information. The administrator is concerned about sending this traffic in clear-text across the private WAN circuit.
What can the administrator do to prevent this problem?

• A.Redirect the wired port trafficto an AP-to-controller GRE tunnel.
• B.Convert the campus AP into a RAP.
• C.Enable AP encryption for wired ports.
• D.Enable IPSec encryption on the AP's wired ports.

An administrator moves an AP from one campus to another. However, at the second campus, the moved AP does not connect to a controller and download an AP Group configuration.
Which process should the administrator perform to reset the AP tothe initial state?

• A.From the AP's CLI, toggle POE on the AP's port.
• B.From the controller's CLI, reboot the AP.
• C.From the controller's CLI, stop the autoboot process of the AP.
• D.From the AP's CLI apboot mode, execute a factory reset.

An administrator implements a standalone controller that runs ArubaOS 8.x. Which feature should the administrator configure to optimize the RF operation for the company's WLAN?

• A.ARM
• B.Zones
• C.AirMatch
• D.Clustering