Free Access HP.HPE6-A72.v2023-12-25.q36 Practice Test (Page 5)

Question 16

Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?

A.The command page

B.The command more

C.The command terminal length 30

D.The command less

Question 17

Which Ethernet port combination does the Aruba 5400R ZL2 switch series support?

A.Gigabit Ethernet, 25 Gigabit Ethernet, and 40 Gigabit Ethernet

B.10/100 Megabit Ethernet, Gigabit Ethernet, and 40 Gigabit Ethernet

C.10/100 Megabit Ethernet, Gigabit Ethernet, and 100 Gigabit Ethernet

D.10/100 Megabit Ethernet, Gigabit Ethernet, 25 Gigabit Ethernet, and 100 Gigabit Ethernet

Question 18

What is the Link Layer Discovery Protocol?

A.a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4

B.an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP

C.a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system

D.a standardized protocol for communicating directly-connected device information and capabilities.

Question 19

Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?

A.Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y

B.Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y

C.Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y

D.Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2