Online Access Free HPE6-A79 Practice Test

Refer to the exhibit.

After deploying several cluster pairs, the network administrator notices that all APs assigned to Cluster1 communicate with MC1 instead of being distributed between members of the cluster. Also, no IP addresses are shown under the Standby IP column.
What should the network administrator do to fix this situation?

• A.Enable Cluster AP load balancing.
• B.Rename the cluster profile as "CLUSTER1".
• C.Apply the same cluster profile to both members.
• D.Place MCs at the same hierarchical group level.

Refer to the exhibit.

A network administrator completes the initial configuration dialog of the Mobility Controllers (MCs) and they join the Mobility Master (MM) for the first time. After the MM-MC association process, network administrator only creates AP groups, VAPs, and roles. Next, the network administrator proceeds with the configuration of the policies and creates the policy shown in the exhibit.
Which additional steps must be done to make sure this configuration takes effect over the contractor users?

• A.Option C
• B.Option D
• C.Option B
• D.Option A

Refer to the exhibit.

A network administrator adds a Mobility Controller (MC) in the /mm level and notices that the device does not show up in the managed networks hierarchy. The network administrator accesses the CLI. executes the show switches command, and obtains the output shown in the exhibit.
What is the reason that the MC does not appear as a managed device in the hierarchy?

• A.The digital certificate of the MC is not trusted by the MM.
• B.The network administrator added the device using the wrong Pre-Shared Key (PSK).
• C.The network administrator has not moved the device into a group yet.
• D.The IP address of the MC does not match the one that was defined in the MM.

An Aruba Mobility Master (MM) - Mobility Controller (MC) solution is connected to a wired network that is ready to prioritize DSCP marked traffic. A group of WMM-enabled clients sends traffic marked at L2 only.
What must the network administrator do to map those markings to DSCP equivalent values when traffic is received by the APs?

• A.Enable WMM in the SSID profile.
• B.Enable WMM in the VAP profile.
• C.Enable Skype4Business ALG Support.
• D.Enable traffic to be marked with session ACLs.

Refer to the exhibit.


An Aruba network is deployed with L2 and L3 Mobility Master (MM) redundancy across two datacenters, as shown in the exhibit. The network administrator confirms that all Mobility Controllers (MC) are currently communicating with MM1, which is the L2 Active and, L3 Primary.
Which MM IP will MCs communicate with if MM1 fails?

• A.10.1.1.12
• B.10.2.1.21
• C.10.1.1.10
• D.10.2.1.10